Rheingold ISTA D - BMW How to reset transmission/gearbox adaptation values

BMW Diagnostics with ISTA - How to reset transmission/gearbox adaptation values with ISTA D.

The information contained on this video are for educational and informational purposes only.
We accept no liability for incidental or consequential damages and assume no responsibility or liability for any damage suffered, as a result of the use or misuse of any of the information or content on this video.

[ShondysGarage]

a huge bravo to whoever does all this useful videos!

[panagiotis]

For e60 2007 530 I how do I reset the transmission adaptation with ista from limp mode?

[mikimiki]

Hello, do you have a video for throttlebody reset with ista ?

[hanynowsky]

After you reset adaptions, did the car start up? No limp mode or error codes on transmission after reset?

[yourfavoritecio]

Do you have a video on how to update the software for your transmission?

[konel]

I have the isssue that after shifting the car from 2-nd to 1st gear the car gives a little shock...but this applies also in Neutral Mode. Do you know what could be the cause? No errors...

[justgodfatherme]

Hi everyone
Can someone explain to me which cable to use for ISTA+ 4.32.15 for bmw f30.
And is there a possibility that ISTA works faster, I need 30 minutes to load the "Control unit tree"?
Thank you

[bombaclatskibidi]

hi the reset transmission/gearbox adaptation must transmission cool or hot for bmw 6hp19

[maltiveru]

Hello
MKAutoTech. At 2:32 on the video there is an option listed as "Oil Change". What does that do please? Thank you.

[erik]

People say you can reset the transmission adaption by pressing gaspedal for 1 minute while ignition is on. Does this have the same effect or do you have to code to clear adaptations after working on the trans?

[octavianmihaescu]

Hello!
I have a BMW f30 320xd, some time ago I received an error on board (Driving Stabilisation), the car now only enters comfort mode and I have traction only on the rear wheels, after some investigations I found the following codes: 48097D (Transmission box transfer - open clutch position, rear drive only) and 440101 end of transmission reached, I mention that the error appeared in the morning immediately after starting the engine.

The car is from 11.2013 and has 292000km, the first owner changed the entire transmission in 2016 under warranty in Germany
I thought maybe the clutch in the VTG was worn out. Initially I thought it was the actuator and replaced it, but the error reappeared after 3 days, the computer communicates with it but I can't clear the error, so did the first actuator. Is it possible to clear the error (440101) somehow and recalibrate the actuator? I mention that the dashboard warning appears only after starting the engine, if I just turn on the ignition, I have no errors
Sincerely, Octavian!

[mohamedeltawab]

I need to reset adaptions after transmission oil change, I cannot see Adjustment in the list, only Oil change which at the end gave me 25% to 100% without the clutch vales. Is it sufficient or should I get another ista+ version?

[devanhixson]

I’m using protool I’ve recently replaced my transmission solenoids and sleeves, also put fresh fluid in. Do I need to just clear the transmission adaptations? Or do I need to reset the value adaptations as well.

[mariantiugan]

Hi, please help me with any good advise i have mini cooper sd LL 2016 with 2.0 and my automatic gerabox and when i start the car skates, after 80/km/hour the car would'nt skate, so CAN you think if i'll do 1 diagnostic - icom ista d - and i reset the gearbox then after WORK properly, or is other thing/method to do? or is broken the gearbox ? thx to answer me

[gireadaalexandru]

Hello. What make Mechatronic Calibration ? When is good to use ?

[UssGo]

After this, my 535d f10 has a delay when put in D. It takes 2-3 seconds that the car pulls forward. The will engage to D on screen but will rev without moving. Help please.

[Jakes-Garage.]

I didnt have tcu only etc and didnt work?

[INAPVBG]

Hi, I have never changed oil in gearbox (automatic transmission e60 2010), mileage 350000 km. Is it late to change oil? The transmission is still perfect and smooth. My mechanic said that I may have problems after change on this mileage
Thanks

[Filipp]

X3 2007 Display button greyed out can't click it. What's could be the problem? Ty!

[Heartbeatpb]

Hi can you help me. I made everything like you but after 2:41 i cant do it. I cant select the abl