Raise3D Hyper FFF Upgrade Tutorial for Pro2 Series

[scogadots]

I completed the upgrade last night and went well despite the instructions. The calibration piece that prints has the smallest bumps and is very difficult to measure. Overall very happy with the speed performance and quality of the printed pieces.

[pedroblas]

I have a pro2... what is the exactly set up for those three drivers... is confusing in the video and at the web site...

[kylebondo]

What is my switches 4 & 5 for 6 bit were already turned on? Just leave it alone?

[HenriDUCOIN]

Bonjour, j'ai un un soucis avec ma raise 3d pro 2 plus.Je pensais que le hyper speed était une mise à jour et non.Résultat machine en panne.Meme soucis que certain seulement 6 bits.
Impossible de remettre l'ancienne version.Avez-vous une solution?MERCI

[AndyDeMeyer]

Will the option to upgradealso come for E2 users?

[DERherbie]

the european support tells me at pro 2 8 bit . Switch 2-4-7 Off . many have problems.
when will there be a beta version?

[mrnmnew]

will this update cause more wear on the printer?

[kirkd]

could use some elaboration on how to figure out if they are 6 bit or 8 bit. you say we have to determine which but you don't say how.

[markuswolfarth]

Worked with my Pro2 only a few days. Then suddenly no more printing is possible in hyperspeed mode, the print aborts with the message "Board Error". Raise knows about the bug for almost 3 weeks now and does not comment on the issue. Communication is zero, that's what I call service!

[joreis]

Hallo Raise, ich habe 6Bit Treiber! Dort ist PIN 2 Aus und alle anderen Pin auf on gestellt!
Passt leider gar nicht zu dem Video! Vorausgesetzt die Beschriftung der Treiber ist Richtig und ON ist unten!😵‍💫 Also am besten weiterhin Finger weg von dem Update!

[samanthairizarry]

This four hump measurement is really questionable, It's very hard to tell when the humps start and when they end. This system should be reworked, I haven't been able to get a good print since the update, in hyperspeed or at normal speed.