Current / Parasitic Draw With Amp Clamp - The Best Way To Test

Current / Parasitic Draw With Amp Clamp - The Best Way To Test
Using the Fluke 88 meter along with the BEST amp clamp for low current draw around battery cables using the Fluke i30s amp clamp. Fast and Easy way to see if there is a draw without any disconnecting.

[masongray]

Love your channel I got an old Briggs & Stratton D/C shunt work great with my pico for small parasitic draw

[rubiconklbrutorowman]

SHOULD be longer video with *detailed close up how to connect like **remove fluke DMM's plug and **insert WITH Amp Clamp and to connect near battery terminals and reading see HOW MUCH parasitic drain occur, which should be below 50mili meter and there is minimum figure numbers, and Amp clamp has VERY small number of min and max figure show and we must use in *milliamp rating numbers to read and multiply by using either min or max but use min numbers usually. and min fig reading in the meter should be multiped by 10 and max figure numbers should be multiplied by 100, which usually using minimum figure numbers to multiple are the steps WHAT this video should be. Too short, but generally OK video, so just subscribed.

[petertorro]

Good video, Is it posible to measure on the positief pole?

[stanjong]

Hi what amp clamp attachment you rocking there ?

[TheMeisterKang]

I have a quick question.

can the Fluke I310s AC/DC Clamp Meter be connected to a PicoScope to view waveforms?

[ITWorksSoftware]

Got a better way than to use $500+ clamp attachment? Any reasonably priced DC Amp Clamps that can measure mAmps ?

[mantolaman]

Where does the wire leads go to for the ammeter?