Spirit Aero gyro install and set up on HSDJETS Super Viper Turbine 'NOT FOR KIDS'

Spirit Aero gyro install and set up on HSDJETS Super Viper Turbine with stabalzation and banks.

[paulsnapp]

Hey Noonz - You were 100% right on with the turbine placement. I installed mine at 5/8" on the nose. I fired up the turbine in the plane today and there were no issues at all with heat in the turbine bay. In fact, it pulls such a vacuum down the exhaust tube that it sucked the turbine hatch down tight out of my hand as I was putting it in place. Thanks for the tip and the heads up!!

[paulsnapp]

Hey Noonz - Thanks for the turbine install videos you sent. Mine is all done - 5/8" in the nose!

When you get a chance, if you could share what you ended up using for your high and low control throws and flap deflections I would really, really appreciate it! Also, if you did any flap/elevator mix. Airborne!!

[Rhoedision]

💯💯💯👊👍👍Awsome bro...well done and great set up..very handy too know and thank you for sharing 🙏🙏👍🤙

[paulsnapp]

Hey Noonz - In this video you adjusted your turbine distance. What is your actual distance now from the end of the turbine exhaust cone and the beginning of the thrust tube inside the bell. You mentioned Terry says 1/2" to 3/4". What is your actual measurement? Thanks!!

[davidhollfelder]

I have one of these Jets, and it has a bad habit. When landing with full flaps (45-50cm from root side), just before flare, about 4 ft above runway, I experience loss of elevator authority (horizontal stabilizer blanket/stall), causing slight balloon then sudden drop. Often resulting in a heavy landing, or PIO (but not pilot induced), and or landing gear damage. I usually can do a go around, then using take off flaps

[junyang]

When to do a helicopter setup tutorial with Spektrum ix12.

[rccosplay]

Looks good 👌 Does this have any "specific thrust" vector control? As I've got the HSD Mirage with 3D pipe. Thanx.