CR 8 Thoughts And How To Laser Engrave With It

This here is the Creality CR-8 that I have received from Gearbest. In this video, I give my initial thoughts and go into detail on how to laser engrave with the CR-8. I have to say this is my new favorite printer.

Printer Specifications
+ 2 In One 3D Printer And Laser Engraver
+ Print Volume 130 x 150 x 100mm
+ PLA/ABS
+ Heated Bed
+ Mostly assembled
+ Great Quality Prints

It is a bit pricey at 369.99 but as soon as I receive a coupon I will post it.

Last Updated June 17, 2018

GearBest June Sales event June 17 -July 9th

Creality CR-10:

Coupons limited:
Creality
S3: US: GB3dpCR10S EU: All3dpGB10S
S4: GBCR10S4
S5: GBCR10S5
Ender 3 flash sale until June 30th $179.99g

Music By:

[MONTY-YTNOM]

Would be nice if it could do thin metal. Like the .5mm two layer. So it cuts through the thin top coloured layer to show the bright layer under.

[jderickt]

Does this model have a pcb aluminum heated bed or is it using a slicone heater pad?

[ripper]

When you say that you can vary the speed by turning the knob back and forth, which knob and which setting were you referring to in order to alter the speed? Thanks.

[joshwigginton]

This seems like something that could be an easy mod or add-on to the cr-10

[danishjaved]

Hey Eric,
On a non related note,
Do you mind doing a walkthrough or showing us the wiring of the inductive sensor for ABL on your cr-10?

I'm getting confused as so how to set it up as my z stop doesn't have a signal port just V++ and GND

[black]

Hello,
do you still have the laser software?
could you give it to me please?
I can not find it :/
thank you

[ihtishamhadi]

I came to this video to find out where the other end plugs into the fan and how and you say u will tell us later in the video and completely disregard what u say, very misleading to say things like that!