Mikrotik Recursive Failover

Recursive Route
Routing recursion is a recursive search process of routers routing table where the next-hop IP address is wanted to route packed towards its destination but when found it is not part of any directly connected network.

Usually, Router checks the destination address inside packets IP header and makes the decision based of few steps described in the routing example above.

When router finds longest match route for wanted destination, the next-hop value for this prefix is read and checked. If that longest match next-hop IP address value is a connected route then outgoing interface is known and layer 2 address is found which enables the frame to be built and transition of the packet can be done towards the destination.

If the next-hop that IP does not exist on any of the ends of connected interfaces, additional routing lookups must be done for an outgoing interface to be found. This additional routing table lookups are known as recursive lookups.

[jaubgallaza]

Sir gagana din ba ito sa PPPOE client na setup?

[cobskie]

sir applicable po ba yan kahit nawalan ng connection ang main? halimbawa naputulan ang main pero reachable pa din sya.. ang s kin kc ayaw mag failover, minsan kc ako naputulan.. kaya ginawa ko dinisable ko ang main....

[rgd]

my problem ata sa ganyan setup sir selective browsing saka dapat po hugutin ang fiber cable from modem para malaman kung nagfailover po talaga hindi po disabled or hugot lan cable. Mas maganda ata sir kung may netwatch pong kasama yan. Gusto ko din po kasi malaman ang tamang pagamit ng netwatch.

[josephminggoy]

gud pm sir, kahit parehong isp is pldt same process po ba?thanks.

[salvadortibal]

sir paano naman pag dual isp with merge at auto fail over via recursive din po sana