Guard Tour Patrol Systems Breakdowns and Solutions

*Connect the smartpen guard tour patrol to the computer with the transfer cable.
*When the smartpen guard tour patrol is connected to the computer or the charging adapter with the transfer cable, the blue LED lights up 3 times. If the charge is not fully charged, the red light will turn on after 3 blue LEDs. *When you remove the transfer cable of the smartpen guard tour patrol from the computer or the charging adapter, the blue LED lights up 3 times, then no light is observed on the pen.
*If the red led does not go out when you remove the smartpen guard tour patrol from the computer or the charging adapter, the pen has protected itself depending on the voltage change. Do not connect it to the computer or the charging adapter until the red led on it goes out completely, wait until the red led goes out (it may be long or short depending on the state of charge of the battery in the red led off time. .). After the red led turns off, charge the device for 1 to 2 hours and the problem is solved.
* When the smartpen guard tour patrol is read to the security points, it gives you a vibrating and light warning. But when you have the same point read more than once, it only gives light and does not vibrate.
*The smartpen guard tour patrol should not be left uncharged for a long time, and the unused device should be charged periodically.
* If your smartpen guard tour patrol has not been charged for a long time, when it is connected to the charging adapter, the red LED does not light up immediately, it is necessary to wait for a certain time. Apart from this, the battery of the device, which is not used at all or is not charged at certain periods, loses its function and requires battery replacement.

Polimek
[phone]

#securitysystems #controlsystems #timeattendance #guardtoursystems