Popup Tent Trailer Height Adjustment

In this video, I show how to adjust the height limiting mechanism on your electric rooftop winch. This model is a 2010 Palomino Yearling 4100. Your assembly may be different. Consult your owners manual for additional questions and troubleshooting.

[WeBuyUSAMade]

The cord is supposed to be taught not loose. Looks like it needs to ho up more to me. You can not put the door in place if it is not up all the way. Ours looked like this with the loose cable and we had a camper repair shop fix it for us. I am glad to now know how to adjust it now.

[seth]

Thank you for the video! I have the same system and it was not raising the roof high enough. Now it does!

[Saltydogmusic]

Hey have you ever had to remove your motor for the lift? looking for direction on that. Good video thanks for sharing.

[marcfesel]

Hi. There is a hex nut on top of the worm drive motor. You should have a hand crank that will fit that nut.
It might be covered in grease hard to see

[dashir]

Is there a way to adjust the actual travel? The plate is next to the gear as far as it can go, but the roof need to comes up more.. i have searched and can't seem to find any info.. any help would be great. Thanks!

[chandoorellana]

Hey thanks for your video . my stop going all that way up so I have issues with the door, so now it doesn't go down at all, is dead . do you guys think is the switch or the motor or do I need to replace the whole thing.

[benjaminluera]

Tim, hoping you get this message. I have to replace my winch toggle switch and ignorantly pulled it to take it in for a replacement before looking at the wiring pattern. That looks like the same 6 pole toggle switch I have on my coachmen clipper switch. Can you please take a look at your toggle switch and let me know how the cables from the winch are connected to the six poles?

[josephkubena]

I have a 2015 Forest River, Rockwood HW296 pop-up camper. When I raise the top it does not stay where I stop it. it tends to wind down a bit each time I stop so I have to keep bumping it and bumping it till it eventually stays were I need it. this could take several attempts meaning ten or more bumps. How do I adjust the break to make it stop right when I need it?

[LUTE]

What if there is an inch difference between front and back height.What would that indicate on a Goshen system?

[cayetanobailon]

Where is the manual crank on this system, I have the same one If someone knows please let me know