Jokari Fizz Keeper Can Pump And Pour Review

Watch the 9malls review of the Jokari Fizz Keeper Can Pump And Pour. Does this product really keep canned drinks from going flat? Watch the hands on test to find out.

Please support us on Patreon!

[noirtrickster]

Read the instructions! You have to push the top down until it clicks twice. It works great.

[sm]

This is a BAD review. I love my fizz and was researching on Jokari - and nearly didn't buy it based on this review. The cans are leaking here 'cos it needs to be snapped into place twice...not once. And you should pump it about 10-15 times though it says four. It works pretty good. It holds my fizz great for about 24-48 hours depending on how much liquid there is and how fast I use it after drinking. I don't usually review products but had to come leave a comment here. 9malls - try this again.

[colaroyaI]

That grey barrel under the lid goes into the mouth of the can. Then you can get your correct seal. Do as many pumps as you need until you feel resistance. I would love to see an updated review.

[jmomoney]

You have to make sure that the Grey ring is snapped onto the lip pretty well. The thing I noticed about the same ones I have is that you have to make sure that lift lever is snapped down like with 2 snaps not just the initial snap. Just push a little harder and the lever will snap down further for a better seal.

[jimc]

Read the instructions and watch the instructional video. To seal, you need to hear TWO clicks.

[kimwinston]

It needs to click TWICE when you close it!

[jimpeplow]

Needed to wait more than 30 minutes. Should've waited 24 hours

[carolcugliani]

Why did you take the top off to pour? The whole idea is to leave the top on, open and pour? Why would you turn it upside down? And soda does not go flat in 30!minutes. I have had mine for years. Fizz lasts at least a week sometimes a bit longer. Sorry a lousy review.

[myopiniondoesntmatter]

I think its because you don't know how to open a can. Why the hell is your pop top still halfway adhered to the can man. You must pop the top all the way through and not bend the opening all fd up like that. Try again mate.

[anthonyherrera]

Try overnight and pour...that's a better review. 😮😢

[exit_]

I ordered some to try, not much of a gamble as they are dirt cheap. Mines don't even fit on my can. The base ring stretches on, but then the cap latch can't go over the outside it fits inside. This wouldn't be a problem if it was designed that way, but since it is not the rubber seal ring does not seat at all. Useless product. Do not recommend.

[SilveniumTheDrifter]

Too bad these don't work. I'll spend hours 'milking' a soda can while I drink less tasty water. :(