Updating the Application using Custom Bootloader - STM32F103 Bootloader Development Part 3

#STM32 #Bootloader #Embedded #Microcontroller #ARM #CortexM4 #CortexM3 #STM32F103 #development

Video Playlist:

***************************************************************************************
0:00 Introduction
0:35 Bootloader Design
5:53 Bootloader Code Explanation
9:43 Host Application Code Explanation
4:20 Bootloader Project Creation and Source code
11:45 Application Project Creation and Source code
11:37 Demo

***************************************************************************************
You can also read,
***************************************************************************************
BGM:

[parveenkumar]

Great Tutorial, all concepts are clear now. You are doing great job!!

[abdodaood]

thanks very much for your tutorials, it's very helpful ❤now I understand the loader and why I need it

[oongibe]

Thank you sincerely.
I saw your nice video.

[elecobot]

Hello friend, plz make a video on Bluetooth firmware update over the air using STM32F103C8T6.

[MerinKumar]

thanks for the tutorial, not many tutorials on STM32F103 are available on net, most tutorials available are on nucleo or disc boards. Till part 2 I have tested and everything works fine. On part 3 wiring i have a question, on the website its mentioned PA9, 10(data Xfer) and PB10, 11 (DEBUG). But in the you tube pic you showed SWD pins are also connected, is that used ? or not needed ?

[bgmuzpn]

hanks very much for your tutorials, but I have a problem that my teraterm doesn't show any information even though I have reset the com port and its speed.

[hoanganh]

I followed your instructions (even using your code from Github) but after i flashed file bootloader.bin nothing happen in tera term, but i keep moving to flash applicaiton.bin file in vscode, the terminal console just show to the step "Waiting for OTA Start" and it stop. Can you tell me where i was wrong?