Chevy & GMC Fuel Pump Replacement || EASY

Learn how to replace a fuel pump in your GMC or Chevy truck or SUV with this easy, step by step tuorial!

Our Socials!

Disclaimer: We receive commission off of sales made through the links above. This does not cost you any extra & we appreciate your support so much! Thank you guys for everything that you do for us.

[OscarLopez-hzsg]

My man you just saved me a lot of pain since my truck is a rust bucket thank you for your video

[DStrayCat]

Great stuff 🙂 I'm using the same #3 method, with a difference... I bought a Marine Floor Access Panel and will install that prior to removing the Fuel Pump in my 2005 Chevy Blazer. Simply cutting a hole in the floor does not close it up when complete. My Floor Panel will allow me to close the hole after changing the pump... Still a great video. Thanks 🙂

[JesusRamos-zszq]

Save me some money Big dog....

Thanks for the dimensions, first time doing it to. But I watched your video about 50 times the night before, changed my fuel pump in a dairy queen parking lot.

[jimmason]

Thank you a million budd y I got an '02 Chevy Silverado 5.3 extended cab and the dimensions you gave were dead nut center thanks again save me about 12 hours worth of labor

[prmayner]

Cutting the bed is the only way to do this job so easy and quick and without running the risk of breaking those plastic fuel lines. One note the purple wire is fuel gauge sending unit, the gray wire is fuel pump 12v and if you look closely there are two different size black wires, the bigger one is fuel pump ground wire and the smaller one is unit ground. I did mine in about 30 minutes including cutting the hole. 1991 silverado ext. cab short bed.

[jamesco]

If you don't want to cut a hike in your bed. There are videos that show how to lift the bed on the drivers side. You don't remove the bed completely. A much harder job when doing it by yourself. Save your bed and time cutting. Especially if you don't have the tools. Or risking cutting stuff.

[julio]

I like watching your videos but I regret seeing wires that way thats for houses

[JohnSmith-xxlx]

I was going to say a good idea would to be get an air compressor or blower out and blow off all the rust after you've broken the ring loose from the fuel pump so the settlement doesn't fall into the tank.

[coolpeanuts]

Always look forward to you guys posting!

[MinnesotaisRust]

This is not an easy job, thanks for sharing!

[FoUoCoKYOUTUBE]

Buy a welders small fire blanket, wet it, place on fuel pump and cut away.

[shanefuller]

I know this video is a few years old, but my question is, would the measurements be the same on a regular cab with an 8ft box?

[jeffbensoutdoors]

Awesome video but you didn’t show how to replace that big hole in the bed cannot weld it over the tank?

[adamgalloway]

To me cutting a hole allows for water to get in and cause more rust issues, my bed has a spray lining in it which I hear makes a mess when cutting the hole, guess I could silicone around it after lol

[PdxGxs]

Should have vacuumed area before removing fuel pump.

[josephnovak]

great video me i would solder wires and heat shrink with

[nottosettle]

Hey in what way did you close up the hole in the bed? Thanks

[ZIGZAGBureauofInvestigation]

Question ? Could the size of your cut on the bed, a little smaller. If you were to do it over, how big of a square cut would make. Great work ! Thanks.

[Mookie]

Man those East Coast vehicles are rust buckets 😮...

[Jabs]

Could i even lift the box if i have 5th wheel brackets/rails?