Boiler not working. How to check heating pump.

Boiler not working, Checking pump, Radiators cold, No hot water

[cs]

Thank you so much, it may be a temporary fix but this has just saved us a very cold night. Worked a treat.

[ourmail]

Thank you so much for this! My boiler was disconnected at work for an extension build and when I recommissioned it I had fault F75. I was getting ready to change the sensor and even the pump but after seeing your video I did what you said and the pump came right back to life. Cheers

[cheaphungerskitchen]

This video was my salvation. Better than the engineer who came to my house, it was me thanks to this simple demonstration of professionalism. 🙏🏾

[alanor]

Just waited 5 freezing days for the Ideal engineer to fix our boiler which was one year old and still under. warranty. He did exaclly you did!

[AlbertoJrGarcia-sfjw]

Thank you i had that same problem with the Utica 150 boiler and i had that 110 error message and this video helped me fix my problem thank you again

[markbalanowski]

Fixed my frozen pump! Made my day, thank you!

[denniscronin]

You have to ensure the heating is off before removing the screw?

[andrewwalker]

Hit the pump with a hammer and bingo working again thank you spot on.

[paranoialikehell]

Thx. This worked wonders. It was jammed and the fix took about 2 minutes

[proplover]

Firstly you should mention that you should turn the power off to the boiler in case it kicks in whilst you are fiddling about with that small screwdriver in the pump. Secondly on the pump label in the 5 o clock position is an arrow - that is the direction of the pump - if you start turning it like you did in the opposite direction there is a good chance you will damage the pump vanes causing loss of pump pressure and having bits in the pump cylinder that will damage other vanes.

[strangerohnostsngerthings]

thank you thank you thank you thank you You're a lifesaver I fix my boiler thank you

[katemackenzy]

Thanks for video. very clear. ok removed the front nut, turned the inside screw- action seems fine...so put it all back together...turned to heat mode...the pump casing itself is getting very hot, is this normal? I can feel vibration and assume water passing through...I have hot water fine...but I only have two large cast radiators on this system, I dont believe they have water in them...as bleed valve produce nothing, but both cold as stone...even though boiler has kicked in, pressure at 1.6...any advice?if I open the feed tap the pressure goes up but not going to the rads.?
TIA combination boiler.

[fablan]

Do you need to turn the water off
Or heating system

[格罗-ky]

Thank you very much! I fixed the heating pump on your advice, thank you!

[fablan]

Do you need to switch off power off to do that

[ForgottenGamesAndMods]

If the pump does not work will you have only hot water or nothing at all (no heat, no hot water) ?

[GayleGrantDocGrant]

When you remove the center screw should this device be plugged in or not? Thanks!

[MrAliCAN]

Just wathced and very good info, just wonder how to adjust speed on this pump ? I have ecotech plus. Thanks

[liaqathussain]

Hi.. My pump is seized ..IV brought a new head.. is that a simple fix or replacement if I did it myself?.

[mrbig]

You want to make sure the pump is isolated before you take that screw out .