Brake pad wear indicator repair

preview_player
Показать описание
Stop brake pad wear indicator warning
Рекомендации по теме
Комментарии
Автор

all sorted - very helpful - only took me 18 months to get round to it !

petemilton
Автор

I had the exact same problem, life saver this video. Cheers mate

johnhandley
Автор

You've just saved me a few quid there sir. Top man thank you 😊

damianeast
Автор

Cheers for this buddy, , , I had this message up, automatically changed the front pads, message wouldn't still go off, see this video, checked my connections and the rear connector was loose, tightened it up, , , off goes the message, , , what a waste of £125 for new pads and labour, , , , live and learn

officaltaffylad
Автор

Thanks for this useful video. After 18 ish months of this message popping up every time I go to start my transit, I can finally go out in my garden & fix 😀

norfolkbushmanandfriends
Автор

Thanks Richard B this problem occurred to me after I had a tyre changed, on getting home I found the sensor wire hanging down, perhaps dislodged by the tyre guy. Tried your fix and worked great, perhaps I will ask the garage to reconnect next time its in for a service but for now its safely cable tied out of the way.

SB-klkq
Автор

Thanks for the vid. My n/s rear brake pad sensor had broken from the pad, tried this but didn't work for me unfortunately 😢

CuillinG
Автор

Cheers. A job for me this weekend to take a look at this annoying issue after I had new brakes and disks fitted.

chrisbow
Автор

Cheers Mr B. Just got my custom back from a brake pad change and the light\beep still on, garage didn't know how to fix it, but now I do, thanks to your skills. Tops.

damianmaynard
Автор

YUP, Just saved another one a trip to the Garage, Cheers!

Marcus-ycqx
Автор

I didn't find sensor at all countries, I will do it at my 2019 tourneo custom van,
Thanx

صالحالسعدون-ثج
Автор

Mine came on today. Checked pads all good. Then seen your video so checked the rear wiring as you state in the video low and behold I have a broken wire but it’s on the opposite side of the plug 🙄

gillerracing
Автор

688 miles in your Mine never says that many, but then again I never fill it right up...

norfolkbushmanandfriends
Автор

So what you did is remove the plug that has the 2 broken wires then you bridged the wires then plugged it back in?
That stops the brake pad warning light?

androidloid
Автор

had this light on the dash, took it to ford immediately as only 50000km of light duty on it and they proceeded to quote 1300aud for new front disks and pads

Sam-esui
Автор

very helpful I do same like you
thanks man

TheKass
Автор

Is this the same for ford galaxy 1.9 TDI 03 models?

youtubefan
Автор

Your fuel tank says 668 miles is that for real?
Mine only goes 355 max full tank. And also isn’t it dangerous to do that as if the breake pads will wear off how would you know?.

iMorinaMusic
Автор

Can you potentially do this to all of the cables?

leemacey
Автор

Is it possible to connect a new sensor though without having to disassemble the brake setup?. I ain't a mechanic and not into taking out brake pads etc to connect a new sensor.

chrisbow