Troubleshooting for PinBrazing unit S30 X/C

This video is a troubleshooting guide for the Safetrack PinBrazing unit S30 X/C.
---------------------------------
CHAPTERS:
● Braze won't start
0:00 Intro
0:06 Check and replace burned fuses
0:33 Check ground cable & surface (use approved grinding tools)
1:10 Check cables & plugs/connectors
2:06 Check & calibrate lift height
---------------------------------
● Short braze, only cap burned
0:33 Check ground cable & surface (use approved grinding tools)
3:23 Store consumables dry
3:53 Tighten flares on the pin holder
---------------------------------
● Interrupted braze, not completed
0:33 Check ground cable & surface (use approved grinding tools)
3:53 Tighten flares on the pin holder
4:17 How to load the gun and braze
6:08 Battery test & cable check
---------------------------------
● Brazing doesn't stick/bond falls off
0:33 Check ground cable & surface (use approved grinding tools)
2:06 Check & calibrate lift height
---------------------------------
● Brazing pin is stuck in the gun
5:00 Check pin & ring holder
---------------------------------
● Brazing time is too long
5:42 Check the pintype setting
6:08 Battery test & cable check
7:34 Inspect the electronics
---------------------------------
● Low charge on the battery
0:06 Check and replace burned fuses
6:08 Battery test & cable check
Test charging with another charger to eliminate charging problem.

============================
EQUIPMENT USED IN THIS VIDEO
============================

[Auban]

Short and informative. Easy to find your solution through the video description. 👌