WHAT'S INSIDE a Pole Mounted Distribution Transformer

preview_player
Показать описание
In this video we are going to dissect a pole-mounted single phase distribution transformer and see what's inside the body and find out all the nuts and bolts that make up a single phase distribution transformer.
Рекомендации по теме
Комментарии
Автор

Thank you! I just started a job building these transformers. I do the internal winding. It was very helpful to see the finished product as everything else is built on another site.

WasteyCasey
Автор

That's so cool! thanks for sharing. I love transformers, it great to see how they're from inside.

jpva
Автор

I've known about transformers since I was a small boy with a toy electric train. And, living in a rural setting, I've been curious about pole transformers and what was inside. They come in so many sizes, from small, residential, to huge sub-station units.

nomebear
Автор

A couple of factoids that many people dont high voltage wire which runs from the overhead line, into the primary coil....exists the primary coil and runs down the power poll into the and there is no direct connection between the primary coil and the secondary coil. The step down voltage is achieved by the number of windings and by induction through the steel core. Cool

darknes
Автор

i was surprised by all the oil inside the transformer case. i had no idea.

hopolo
Автор

At one minute and 46 seconds it's just the gasket you know I LOVE IT !!!

brianhumphreys
Автор

Excellent video, exactly what I was looking for. Thanks

Ryan-mqzs
Автор

Excellent...usefull video. Thanq for uploading...

venkatavenkey
Автор

Thanks for the video Sir, do you know how much the transformer weighs and approximately how much copper weight will be there in the transformer. Cheers from Sri Lanka

donsuren
Автор

Can you take it even further apart? As in take out all of the components, disconnect everything and lay it all out?

guam
Автор

Very interesting how one thin wire goes in at the top and three thick wires come out at the side..

supera
Автор

I'm curious, in places that base their rules on IEC standards or BST standards what is the tap limit for service transformers? In the US it's six for utility owned transformers, and ONE for the same exact transformer if it's customer owned.

genierico
Автор

im newbie to your channel...sir can you explain or make another video that you take out the rolled sheeted thing inside the transformer and labelled one by one...this video helps me but i need more and specific...thank you...from philippines..godspeed👌👍👌

jocelynbruces
Автор

Which country is this in? Your transformer has just one high voltage input terminal, so surely the other end of the primary winding must go to earth. But they're not like that here in the UK, at least not any of those I've seen, here the primary winding is connected to the high voltage supply lines at both ends with the required potential difference between them, and one secondary connection goes to earth to protect the consumers in the unlikely event of interwinding insulation failure.

majorpygge-phartt
Автор

What are the bushing purpose. Allow voltage bleed or suppress it. Suppress the bleed, well allow dissipation without Corona arcing???

ryanb
Автор

How many windings does each coil have?

techmelts
Автор

Hello! Sir, I'm a new subscriber, I'm just asking, what is the use of oil inside the transformer?

digztv-
Автор

I take it you applied lots releasing spray like WD-40 or something similar to those nuts before filming.

majorpygge-phartt
Автор

you dint let me see all. the parts in transformers

frankash
Автор

Is that transformer inactive or is it active

boocatt