QCZEK QLRS DIY LORA Flash and Configure

Flashing and configure LoRa Module same for 433-868-915 Ebyte long range modules

[валералоновюк]

Спасибо, как всегда видео на высоте!!!

[iforced]

Very interesting. Looks like there is a firmware for the 915MHz variant too, nice. The 25mW limit we have in NZ for 433MHz has made me pretty much avoid it completely so far. The 1W limit for 915MHz seems more comfortable if you're actually intending to fly at range.

[josephrossman]

This was very helpful thank you so much.

[ashkananali]

Thank you.
How connect talmatry RFD 900 with ardunio control servo

[istvansoos]

Dear Sir! Very much thx for this video, I finished building 868 version yesterday, works perfect. On the table. Before I build it in the plane, may I ask a question: do you know if I can use m0 to output a servo and m1 to output the rssi? I can not find the answer anywhere. Best regards, Steve

[akinci]

Hi sir I'm using e32 915T30D module as telemetry module for pixhack.
When I try to connect it. It is stuck at getting parameters 1, i can see the datas but not able to upload waypoints or mission. Any idea? Why it is not connecting properly

[Fixaj]

it gives an error check the SWIM cable connection... do you have any idea

[unixoid]

I flashed and configured this LRS, but it doesn't work. The transmitter in the audio speakers is humming, and seems to be working. But in INAV, when PPM is selected, all signals are at 1000 and do not move.
I’m also not sure that I connected the receiver to the FC correctly, I connected the receiver to the FC input on the PPM RX

[fazrulrusdi]

Any reason u start using qczek lrs.. Saw ur previous video on openlrs

[chnstark]

41 / 5000

Where can I buy a module like yours?

[krystianbogaczynski]

Hello. I'm using an external ppm transmitter and a ppm receiver (qczek lrs). when I turn off the transmitter the red parachute is not displayed. Failsafe set to RTH. in my opinion it should display a red parachute. What am I doing wrong ?

[ItaloFranklinTutoriais]

I bought an E32 433T30D and came E32 433T30D 1B what can I do? Thanks

[ЕвгенийМалиёв-йц]

а что означает вот эта ошибка?Error : Cannot communicate with the device !
Check the SWIM cable connection and check all the needed pin connections on the SWIM connector.

If the application code uses Swim Disable and Reset pin as Output or has disabled SWIM Clock Divider:
Try Now to SWITCH OFF and ON the application Power Supply while NRST Reset pin is forced low.

Error : < OPTION BYTE programming failed.

[vasobg]

Is it going to be an update of this video?