Grimsholm Green - Find the cable break with MS6812

ENGLISH VOICE

Information movie how to use MS6812 from Grimsholm to find the cable break in robot mower installation.

[alfredkviseth]

This is the best instruction video I have ever seen!

[jonnorris]

I use it to find problems on the boundary wire for my Husqvarna automower. It is usually easy enough to see where the problem might be if rabbits have been digging. But today I found a loss of signal on a stretch of wire where there was no obvious animal invasion. I cut out the relevant area of wire and on investigation afterwards found that there was a very minor break in the insulation which resulted in marked corrosion of the wire. I could never have detected this otherwise. Thoroughly recommended!

[dr.speschl]

This video is the greatest thing about your product. Thank you for the detailed and very understandable instructions.

[kohlfuerst]

I wanted to thank you today. Your video did help me to use the cable tracker in the right way to find my broken Landroid Worx wire. Thank you, thank you. The ONLY and best video on the internet that shows it fully and answers all questions. I was hunting for that since over 2 years now. That other people can find it too: cable tracker, kabelbruch, rasenmäher, lawn mover, kaputtes kabel.

[philreid]

Great piece of kit, I found the problem very quickly, saved expensive fault finding.

[AliAhmad-xin]

thanks for the good video. I have tried to solve the problem but without success. I have gone all the way around but the beep sound never goes away as if there was no break at all...? and the light on the charger still indicates a fault on the cable??

[notheotherklaus]

I have the same issue, blue light but your equipment says it's ok (cont lamp blinking and I checked sound around the lines at several checkpoints). I also noticed that when it happened - when I got the blue light - that the mower had moved over the cable line with about 50 cm which I found very strange given that the lawn is flat, any ideas? @grimsholm

[eamonhegarty]

What happens if I have a weakened red light on cont mode when I connect both ends of cable. But it’s showing a break in circuit when mower connected. Will I get a stronger noise and weakened one where there must be a partial break?

[AliAhmad-xin]

thanks for the good video. I have tried to solve the problem but without success. I have gone all the way around but the beep sound never goes away as if there was no break at all...? and the light on the charger still indicates a fault on the cable?? Do you know what I'm doing wrong?

[progamerr]

Does this also work when you have 3 wires?

[kickotube]

Doesn't work for my Gardena lawn mover cable ... weak signal, I must send it back.

[philippecalmes]

Does it work, when the cable is some centimeters underground?

[fadein]

Blue light blinking, but this device says the loop is intact 😑 so what now?

[sstrielka]

Just received cable tracker, watched the video... why the F it cant track cable underground..what's the point then...I mean who keeps cable above the ground? Jesus F Christ! Challenge for the user to find damaged part without digging out whole cable, that should be the whole point!

[trulseinarkalkvik-dorleans]

The signal is so week that if you cant see the break with your own eyes. don't bother buing this thing. Waste of money.

[AliAhmad-xin]

thanks for the good video. I have tried to solve the problem but without success. I have gone all the way around but the beep sound never goes away as if there was no break at all...? and the light on the charger still indicates a fault on the cable??