Beginner's Guide: Writing Your First Script on STM32 Using Arduino IDE

This comprehensive tutorial will guide you through the process of setting up and programming the STM32 Blue Pill using the Arduino IDE and a DSD TECH SH-U09C5 USB to TTL converter. The STM32 Blue Pill is a powerful yet affordable microcontroller board based on the STM32F103C8T6 ARM Cortex-M3 processor. Known for its robustness and versatility, the Blue Pill is an excellent choice for hobbyists, makers, and professionals alike who are looking to harness the power of 32-bit ARM architecture in their projects.

Join this channel to get access to perks:

Buy Pre-Soldered at ShillehTek:

Buy Converter:

Link to Blog Post:

TIMESTAMPS
00:00 Intro
00:10 Background
01:27 Physcial Setup
02:58 Arduino IDE Setup
04:39 STM32 Programmer Setup
06:08 Blynk LED Test

[mmshilleh]

If you enjoyed this tutorial please subscribe to the channel! 🎉❤ Thanks for watching :)

[fenix.]

You obviously don't load STM32duino into the flash memory, you don't waste any storage space, therefore you remain dependent on the onboard serial bootloader.

[AshutoshSharma-ou]

should i need to connect usb to ttl connector to stm after uploading the code ?

[pixelrancher]

Was there a link to the Additional Boards Manager URLs? Thanks.

[kirishima]

Showing the physical board setup would have helped.

[robertcameronjones]

Well it's clear ST missed the whole point of Arduino. Teensy and ESP32 are a breeze by comparison.