Tarmo 4 - 3D Printed High Performance RC Car

Little shakedown run of the Tarmo 4 designed by EngineeringNS.
A great driving car once it's set up. Took me around 4 days to print all the parts.
Components:
ESC: Hobbywing Quicrun 120amp
Motor: Turnigy Aerodrive SK3 3542 1250kv
Wheels: ProLine Trencher 2.8 LP Mounted on Black Raid 6X30 Wheels
Shocks: RC4WD King Off-Road Scale Dual Spring Shocks (80mm)
Servo: Savox 1270TG
Differential (front and rear): TRX5382X
Reciever: TBS Crossfire Nano RX
Battery: Turnigy Nanotech 3s 2200mah LiPo

[thesidecharacter]

This is how we get the 1:10th JRX2 back.

[TheBestMobileRC]

This is awesome. your video is amazing. SUBBED👍. Keeping Going

[Pablo_M]

Cool car but a few thoughts on the setup. Ideally the driveshafts are parallel to the ground when the car is just sitting still. Too much angle robs some power and will wear out the drive cups faster. Also lower stance of the car means lower CG and will perform better and less body roll. Lastly it seemed to bounce a lot so maybe your springs are too stiff (could be why it sits tall), or the spring collars could be raised a bit to lower the stance. And maybe try a heavier weight shock oil to reduce bounce and bobbing.

[georgecba]

Great work, thinking about making my own. How much did all the parts cost altogether?

[ElasF]

Do you think I should print the Tarmo 4? Because I already build the third version (I also made a video about it) and I want to print another RC car.
Your video is great!

[kzvvtlx]

Great what type of esc and batterie? :) can we have a description plz

[oliultaj]

Can you provide length, width, and height?

What's the highest jumping height and heighest obstacle it can crawl?

[MrGoodcat]

Impressive work! Which camera do you use?

[kinggc]

Do we have to purchase plans? Where can we get em?