Stepper motor Angle control using Arduino - ZoneMaker

This video is about Stepper motor Angle control using Arduino

A Stepper motor rotate by 4 Buttons degree angle

Hardware
- Arduino UNO
- Button x 4
- 10K resistor x 4
- PowerSupply 12V
- Jumper Wires

Arduino Sketch

::::::::::: SUPPORT CHANNEL ========

→ Don't forget to subscribe!

🌟Love you all! 💕

[chanchalsakarde]

How to automate this ...for example i need to move automatically from 0->180->90->45-> similar way series of angles one after another... is it possible can you demonstrate as challenge

[GreatPlainsChaser]

I would like this sketch to have 1 button, and once pressed pick between 3 random set locations. Please help! Thanks!

[ndduong]

Very helpful. Thank you! Can you show me how to initial stepper motor at 0 (zero) angle?

[callmeqavi]

sorry can you tell me how did you reset to 0 angle cause my keep turning in clockwise and doesnt return to 0 angle please reply me asap cause this for my final year project im really happy if you could help me asap :D

[klockenberg]

So it depends on the Motor Driver's step/revolution? If it's 400 pulse/rev then change 1.8 degrees to 0.9?

[Papa-mbcx]

Thank you for your project, i'am verry happy and need the lessons you give...GBU

[maheshrgowda]

Please suggest me to do 90'rotation stepper motor for 25nm torque

[serkanozcan]

can you share the same thing for 28BYJ-48 stepper motor please

[alexalex-hbdq]

would this work with a A4988 controller?

[xiaojunwang]

this video is very useful to set up what angle to rotate and there is a limitation and if data type of the n inside the code is changed from int to float, it will avoid the resolution problem, like rotate from 9 degrees to 9.5 degrees.

[janmaatuma]

What happens if you press btn1 and btn2 at the same time

[omnianti]

do you have to zero the axis at each reset

[atulthakare]

Can u please share code link? Your description link is not working

[NAMHOANG-]

Hi Sir, How can I stop step mortor by button when the proggram run

[electroniclover]

Can a4988 driver control like this >??

[machirajuramaprasad]

Can we rotate for 4, 6,9,10,12,15, 18 degrees?

[Yusuf-dxhw]

I wanna say thank you so much but I planted this circuit irl but it doesnt move.It shakes but doesnt work properly.I think it is because of my supplier .Could you help about it ?.What kind of supplier should I use for enough power to driver and motor?

[luthfiachmad]

will it work with 15, 30, and 60 deg? please answer :)

[indranilpatil]

It really help me .... I have been looking for nema 34 .. so which driver would be better and do I need to change anything in program

[ALEXWATSON]

You know how to make something like that but without buttons, just automatic but 2 second delay between each movement?