SolidWorks Tutorial Piston & Connecting Rod

SolidWorks Tutorial Piston & Connecting Rod
Watch Complete tutorial video of piston & rod how to make and Assemble in Solid works please like & subscribe our channel for more videos

[elefja]

Learning Solidworks and these projects are helping me greatly! I did however change the hole diameter of the connecting rod to match the piston pin OD and it looks a lot cleaner. Thanks!

[margiemouse]

Commentary would help immensely to actually understand the tools and processes used.  The problem is if any tutorial uses a tool or operation the viewer doesn't know it is lost with out explanation. If the tutorial uses tools the viewer knows then we didn't need to watch it in the first place. These videos could be really effective teaching tools if explained (yes - nice to try and break the language barrier but it would be better to make a powerful teaching video for fewer people than a watch me video for more)

[cianwalsh]

why is the outside diameter of the pin smaller than the hole at the end of connecting rod where it attaches to the piston ? There is a gap there that would mean that the connecting rod is not correctly attached? thank you

[GBirkol]

what is the lenght of the rectangle which situated middle of the part (6:00)? thanks

[johnkaradimas]

Thankyou very much for all of your well presented and explained tutorials.
Is the any chance to do a tutorial on how to model Aluminium composite material? or have you already done one?

regards
john

[wasilkatchi]

Dear sir
I have been following your SolidWorks tutorials for quite a while now and so far they have been a lot helpful.
but I came across a doubt at the mark of 31:14 I followed everything but by 31:16 I couldn't figure out how you were able to freely rotate the piston about its axis!
I've put in the mates correctly but still wasn't getting it.
I even made the connecting rod to float.
Your help in this matter will be greatly appreciated!

Regards
Wasil Katchi

[xBlackThoughts]

A very good video apart from a few small glitches. 🙂

[mridulsarmah]

It would've much better if you have shown a 2d drawing for reference before going for 3d. Now its hard to figure out how much is the dimension of the rectangle and its proper placing

[kirankumar-xnkr]

Which laptop you are using to design all these.

[nashriqawang]

Why my size of the screw hole is so small.. I've follow every step u do but it doesn't change

[shikunchen]

Hi, Sir, Thank you for your video. I have a question. On 6:30, The Rectangle is not full defined? It's Ok?

Thanks

[NiteshKumar-njwj]

This dimensions is random one or for any specific vehicle

[mitsubishitiengiang]

Hi Sir, thank you for your video, but I have a problem, at 31:15, why I can't rotate the connecting rod?

[sunnywaje]

my connecting rod is freely moving 360 degree, i want my rod to be stop at the piston border

[ahmednouh]

sorry, can you explain how you could make the animation at the end of video ?

[paal]

12:15 I can't do it. Is there a solution?

[ragheblahbazi]

sorry can you give us 2D drawwing to learn more

[alrawahikhalood]

where can i find the 2D drawing ...thank you

[shreearavind]

doing this in fusion makes job much easier.