Scott McGillivray - DMX 1-Step 2.0

[Simn]

Shouldn't you be installing the floor on the opposite way of the dmx ? So the mine doesn't matches between DMX joint and laminate flooring

[petertrigiani]

Does these of DMX invalidate the warranty of manufacturer of vinyl flooring such as TORLYS ? What is the minimum thickness of vinyl flooring that I should consider buying in order to use with the DMX Membrane ?

[ericcote]

Maybe this is a silly question, but how do you properly finish the perimeter if it’s supposed to have an air gap to let moisture out? Wouldn’t raising the moulding a bit look incorrect?

[hemusbull]

I did part of my basement flooring (not finished yet), using laminate on top of DMX but it's kind of sqeaky on some spots...😢

[michelebrowne]

1:20 pm if my spc vinyl planks have 1.5 mm underpad attached will the DMX1 be too much for the interlock system, ie seams coming apart?

[michellericker]

Does this product make your floor feel spongy? Plus I'm seeing where it suggest using OSB over this for LVP flooring, is this needed or not?

[benoitlaforest]

If there is vapor coming from the concrete slab under, where does it evaporate? Won't it end-up doing condensation?

[madukabandara]

Thanks in advance. Please see my question below.
Minimum LVP thickness requirement of 5mm that DMX 1step 2.0 support, does that have to be the LVP core or the total thickness of the LVP including wear layer and attached underlayment? For example a plank with thickness specs as below 3.5 mm core + 0.5 mm wear layer + 1 mm IXPE underlayment.

[alancongratssoonyoullhead]

Hi Scott
Where can we get DMX 1-Steps 2.0 in Toronto and Calgary area?
Thanks 🙏

[atarileaf]

How hard to cut circles our for toilet flanges and drains, etc?

[BobRutledge]

How about spray glue by 3M. Just a spot every few feet should hold it flat till the flooring is installed.

[savyrr]

What’s the difference between this and the DMX air flow ?

[tokentoker]

Did u put tape at the edges to keep the dmx in place on concrete?

[anthonyrochon]

Anyone; I'm looking for onfo on basement floors how necessary is it to seal the floor? Built in 1954

[doctordutch]

Why doesn't DMX respond to these comments/ concerns?

[animalchin]

Hmmmm the instructions say if the wall is finished foam the edges up to the drywall.