Mecpow X3 Pro – Setup and Initial Thoughts!

If you have any questions on the content covered in this video, feel free to leave a comment below with them. I try to reply to all comments within 48 hours.

Resources

Recommended Hardware

Mecpow X3 Pro 5W
coupon code: CONSUMER10
after coupon: $189.99

Mecpow X3 Pro 10W
coupon code: 7RT05F8L61
after coupon: $264.99

Videos

Links

Need Assistance?

[adamdicken]

Your comment on the emergency stop saved me an afternoon of frantic forum searching. Thank you!

[keliiwilliams]

OMG, do you realize your video is the ONLY detailed one I’ve found. I couldn’t install my drivers for 4 days, going back and forth with CS, thank you so much!! Turn on the laser before installing the driver!!

[danielspencer-th]

Very very helpful, thanks for doing this video.

[UnboxEcc]

Hi do I need to change the line interval/DPI settings in lightburn for the mecpow x3 pro w10 when engraving a photo? If so do you have any good setting? Thanks.

[aliciajasondodd]

How do you ventilate it I’m looking k start engraving first time and have no clue what’s needed if I have to purchase extra materials or how I would ventilate

[GhostofTatooine]

wow, to the UK without shipping £215 for the Pro. Amazing. I would be cutting 3 -6mm ply and some 12mm EVA foam and maybe some 5 - 6mm oak sheet that I have. so I am thinking the 5w would be a better option but if the 10w Pro cuts cuts 3/4 oak that is amazing. Looking forward to see the next video on the cutting side of things.

[alexss]

How much thickness is the focus card? Mecpow send me a machine without it 😅

[SebabsUnbox]

WhaT about engraving on tumblers? How good is it?