VIFLY Finder 2 Drone Buzzer - How to Use

preview_player
Показать описание
The tutorial video shows how to install the VIFLY Finder 2 on a FPV quad or a RC airplane, connect to a flight controller or a receiver. Check the video to learn how to use the FPV buzzer to find a lost a crashed drone.

Рекомендации по теме
Комментарии
Автор

This video needs a little editing. The music is to loud and the voice is not loud enough.

sparrow
Автор

How can I charge this off a drone? I have a few that are going to be shelved for up to a year and I need to storage charge them first.

CriticoolHit
Автор

Could you raise the volume of the music a little louder before the 2:35 mark. I think I could actually hear the AI voice over the music, and we don't want that do we? 😂You'll have to add the music after the 2:35 mark since it was gone, and I could actually hear the AI voice! 🤐

hifinsword
Автор

question about buzzer, , , I fly my drone at sunset a lot, and lost my drone at dawn, if i buy this unit and lose it after sunset how long do i have to find it before the buzzer goes into hibernation? i would rather not leave it over night it rains at here all the time lots of passing showers in Hawaii.

lschevy
Автор

how do we tend the battery if we don't fly a drone for a long time? Will it charge by plugging 5v usb into the FC??

FourthWayRanch
Автор

Mine kept going flat after a few days.
I checked current draw and found that the buzzer is constantly drawing 0.5mA from the built in lipo.
So the onboard 80mA lipo will go flat after a week if it's fully charged.
Not sure if mine is a faulty unit, or if this is normal behaviour.

chifpv
Автор

Can this connect to a Holy Stone F181C or similar? I've never looked at it's flight controller to see what it has for leads.

danielharmen
Автор

When I alarm by controller it is very quiet. The other modes work as expected

djrodriguez
Автор

when disarmed will it auto arm when you plug in a battery

frankdoingthings
Автор

Just installed mine no beeps only red flashing light when lipo connected to drone.. disconnect lipo beeper does nothing..

serval_fpv
Автор

Hello,
I just got my vifly finder 2 from Bangoood. Unfortunately the Buz- header on my flight controler is damaged. Can I replace it with another channel?
Thanks.

TheChristou
Автор

Mine almost never disarms properly and it is super annoying

robrever
Автор

Music too loud, computer-generated voice really annoying. I made it 39 seconds and had to stop.

keitharoo
Автор

There is no way to attach this to your drone. No attachment point, no through hole, nothing. The best I could do is shove the smallest zip tie through thick plastic shrink wrap tube and circuit board and zip tie it to the frame. I was like, are these guys serious?

It's also a PITA to charge up before you fly. I had to make a special battery tray just to charge it up. I end up charging it up, zip tying it onmy quad, and then before take off and activate ti and let it beep away while flying. Kind of really stwpid design.

Then when you are done, you have to cut the zip tie, and put it back in your rerigerator for storage, and repeat the process every tiem you want to fly, sacrificing a zip tie and a lot of time each time you fly.

choppergirl
Автор

I can't even watch.... Try again pal

jdc
join shbcf.ru