DIY Drum Sander For Drill Press | Quick Sandpaper Replacement - NO GLUE | XDIY

Показать описание

I made a homemade spindle drum sander / spinning sanding drum for my drill press, for for sanding holes, edges, contours and irregular shapes.
In my drum sander, I made it easy to replace the sanding papers, and without glue usage.
What do you think about the video and result? write me in the comments.

Watch my DIY Woodworking Projects -

#xdiy
#xdiy_with_itzik
#itzikdiy
#diytools
#diytool
#drumsander
#sandingdrum
#drillpress
#spindlesander
#homemadetool
#woodworking

🔔 Subscribe and click the bell, so you won't miss any new released video! 🔔
Thanks!

Credits:
תוף ליטוש למקדחת עמוד - עשה זאת בעצמך

Рекомендации по теме

Комментарии

If you like my project, please hit the thumbs up on the video :)
What do you think about the result? Write me in the comments

XDIY

Great job, I have been wanting to make one of these for a while! Really like the use of the piece of metal to clamp the paper. Thanks for sharing! 😁

tfturning

Getting the paper to hold onto the core was what I was trying to find a solution for. Nice work. Thanks for sharing! 😀👍

YoureNowOnTV

Creative and inspiring people. Thank you so much

Cahsolotree

Yes i do like your video brilliant ill get out there and make one many thanks👍👍👍👏👏👏

keithdavison

תודה רבה וידיאו מצויין!
המבטא מוכר...

ברוך-עו

Bom Dia, exatamente o que eu precisa aprender, valeu !

luizcarlosvital

Isn't this bad for the drill press alignment?

barwithm

It would be beneficial to add another metal strip to the opposite side of the cylinder to help balance the drum and reduce vibration.

GLHerzberg

I see that you are also a fisherman. You have so many bamboo fishing rods behind the machine. Good luck with everything!

ВладимирЛапиков-ьъ

I purchased a set of 4 size drums at harbor freight for 15.00.

lesd

So when paper is done, and you have to change, the screw must be unties, and screwed in again i. The same hole. So that gives it a short timespan, becsuse the holes will not fit the screw after short amount of paper change? Perhaps some threaded insert to screw a bolt into, rather then a metal screw to wood?

silasgroenning