EZGO Charger Receptacle Bypass: The Ultimate Upgrade Hack

Join this channel

[AllenCrumley]

Huge thanks for all the videos and posts. I have a 48v RXV that will only charge if I turn the lights on. I found that little bit out after replacing the charging port on the cart and the connector on the charger. Any ideas why it might not be charging without having to turn the lights on?

[tsfcollies]

I'm doing a battery conversion on my 36v Ezgo TXT, going to lithium. This info is exactly what I was looking for. Thank you for posting this!!

[jakeparker-fg]

Hey so I bypassed the switch like you said. I’m reading 49 volts but my quiq charger just steady blinks red and won’t charge. Any ideas. Thanks.

[rmstark]

Couple questions. My plug blinks sort of quick green when charging. Eventually it turns solid green. But then I get maybe 20 minutes of runtime . I put my load tester on three batteries it registered bad. I hit the load barely mover the needle in the bad area. I a quiq charger and have no clue what the lights on the charger mean there are so many.

[jamesmulhall]

Hey I have a 2011 ezgo txt 48 volt. I just picked it up and the charger is flashing fault. I did some research and I have that blue wire plug at the back of the receptacle but nothing to plug into it. I read the comments and you said that means they bypassed it and should be hooked to the main positive post but I don’t see anything hooked up there. Any idea where that wire comes from that plugs into the blue wire connector at the receptacle thanks man

[joshwix]

where does the red wire that you unplugged from the blue wire go, my blue wire is just hanging there with no connector on it. trying to find that connector and red wire that you unplugged the blue one from.

[kwsimmons]

1:56 where does this end go? I do not see this in my cart but it was not wired properly.

[Cypherpunk]

Hello I just bought a new charging port and when the charger is plugged in and says charging the new green light still isn’t flashing.

[rhinoandthedood]

Hey brother I got 2008 rxv. I just fully charged it and topped it off with distilled water. I took it out for a cruise and when I got back and plugged it in it gives me the 2blink red fault code It still functions goes and stops forward and revers but only a matter of time. Any insight?

[FuNPeopLe]

All I need to do to bypass the reed switch cable is connect to the positive of the battery??? 👍

[stevenclavell]

I was just wondering if you did any video diagnostic via FaceTime or anything for hire

[marwan]

I don’t have a blue wire just a red, black and white I’m confused..

[jamesmulhall]

Hey I have a 2011 ezgo txt 48 volt. I just picked it up and the charger is flashing fault. I did some research and I have that blue wire plug at the back of the receptacle but nothing to plug into it. I read the comments and you said that means they bypassed it and should be hooked to the main positive post but I don’t see anything hooked up there. Any idea where that wire comes from that plugs into the blue wire connector at the receptacle thanks man