#540b TinySA and NanoVNA Fight

Episode 540b
The TinySA measures the NanoVNA. The NanoVNA measures the TinySA. Who will win?
Be a Patron:

[ErikKaashoek]

The nanoVNA can not output above 300MHz, it uses harmonic modes above 300MHz. If you set 800MHz you get 266MHz

[etow]

Can any of these sweep above 600MHz ? I need one to see if any LTE signals are interfering with OTA channels in the 5-608Mhz range.

[jfcrow]

Low is 0-300M and High is 240-960M You need to change the input to high of the tinysa

[kddnk]

You need to change the input on the sa to read above 350 mhz

[mrenrollment]

it would be interesting to see Nano on o-scope also, ...

[johnwest]

You did everything I did with mine, including forgetting that the LOW input couldn't see 440 MHz. :)

[rayerdinc]

Just love your videos Sir! I am not technically mimded on this subject amd don't follow everyting but your style, voice and presentation makes it so interesting, keep them comming please. Subscribed.

[marcseclecticstuff]

The 146.527 spur amplitude just about disappears after you reconnected the cable. As you were tightening it, the amplitude of the spur went back and forth between ≈-35 and ≈-50 dB, ending up settling at ≈-50 dB, starting about the 4:17 mark. Dodgy cable, connection?

[DennisMathias]

You've demonstrated that you can use the VNA as a signal generator! That's great! I mean, it has to do that to measure SWR but makes me wonder if you could do receiver alignment, etc.

[ErikKaashoek]

Your SMA cable may have an issue in the second half of the video

[batfalcononyoutube]

What is an approximate RF input signal that Tiny SA can handle without damaging it?

[BryanByTheSea]

Don't you have to connect to <-HIGH-> at 440M

[zachgr]

I feel that both models are of the same design!

[kradio]

Hi. Can you review and compere nanoVNA-F

[warplanner]

We have a little too much time on our hands do we, IMSAIGUY?

😝