Basic STANDING SEAM Metal Roof | How To install.

In this video we’re doing a basic standing seam metal roof, I hope y’all can learn something, and just be aware this might not be the exact type of trim and panels that you have access to in your area, but some of the basic principals could still apply. Also normally you would probably have an “A” Frame roof your working on, not a Lean-to like this one, in that case line up your Rake, (Gable, or Corner) trims up at the peak, and make all the points meet. On another note, Some metal roofing shops can make custom trim so take advantage of that,

Here are some of the tools we like to use, these can be found on amazon via the following links;

You can also get this in a 24” length for Hemming the bottoms of valley angles on standing seam.

(AKA) Hiking Boots)

I am an Amazon associate, and may earn a commission if you purchase any of the products using the links I have listed in the description.

[MiloLagrange-sl]

And now cue all the smarter guys that know it all but would never have the balls to put a video out there. You did great. Nice neat work.

[kevincorbin]

Being skilled with a shears is often overlooked talent

[russellsroofingknoxville]

My dude knows his stuff! You can tell when you’re cutting it! Good job bro! Love the video

[TheJuliomguarquila]

I like the video you guys did an excellent job of showing and explaining.

[briangagen]

Done shingles before but this is a first metal roof for me.... your video has been extremely helpful. Straight forward instruction.
Thank You

[nickles]

I liked your presentation. I just need more tools 🥰🥰

[jimcotner]

Thanks guys, It's nice to find DIY videos made as well as yours. I can't think of anything that would make it better. Thanks again.

[nickg]

Very nice! I've seen SO many vids on SS and they try to complicate tf out of it. Thanks for the step by step clear instructions/vid

[jasondimartino]

What an amazing video fellas, thank you for sharing. Very well done!

[franzteichroeb]

I like the video you guys did an excellent job of showing and explaining was a great help

[johnbruzzi]

Nice work guys, can you make a door to close the end on the overlapping panel at the drip edge

[fungihntr]

Excellent video! Thank you. I am curious to know how the last panel was fastened to the roof.

[pacificnorthwest]

What is with the second story door leading out to the shed roof top?

[propertyrightsmatter]

Curious where that second floor door leads to, or maybe it's being removed?

[madman]

Why is there a doorway going to a sloped roof?

[b.b.]

Great video. Why do you bend the sides and fold the edges?

[jims]

The rake trim on the panel end are not mechanically fastened. It’s a friction fit. For a small barn no issue, but you’d never do that for something that needs a wind uplift requirement

[EI_Tony]

Any videos on how to install metal panels with 2inch foam in between sheets .... They're 4x8 with ridges about 10inches apart.... First time doing this type of metal roof I'm just trying to see what I can put on the top, side, and bottom edges.... Boss bought these looks like they were sawed off an older roof so the foam in between sheets have no slope .... Any advice or ideas would be appreciated thank you 🤘🏼

[mikemillett]

How is the last panel attached to the roof?

[ojibberwe]

Pretty low slope roof to be using metal, and a 1" lap on drip is a little short as well. With the amount of snow up there, overboard is a good practice.