AXIAL RYFT BINDING ACCESS

AXIAL RYFT BINDING ACCESS for those of us that don't want to take the cage and shocks off there is an 11 screw method I discovered. This is the video of that method. Please Like and Subscribe!

A couple notes - make sure you have good batteries in your controller and a fully charged Lipo. Also, don't touch the dang car after binding it for 5 seconds after you power it on. Just like a gyroscope on a drone Spectrum's Smart Telemetry and AVC Traction control and Smart ESC are super sensitive. So during that time it's calculating the space time continuum.

Battery plugged in. Car on. Hold down mode button for factory reset for 5 seconds and watch the ESC blink. Then push the little bind button, should blink fast orange, hold down bind button on controller and power button and then follow the instructions. Throttle pull. Release. Reverse push. Release. Controller wheel right, release. Left, release. Power off. Then power off your controller for good measure. Turn on controller. Turn on car. WAIT 5 SECONDS. Should be good to go.

Set your trim knobs at a neutral (center) position for bind.

Really hope this speeds up binding for you. can be done pretty quick even in the field.

Thanks for watching!

Like and Subscribe and hit that bell!

[norcalrc]

Love the Ryft videos, keep them coming. I eliminated the receiver box from the front lower chassis and placed my receiver in the fuel cell located in the rear of the vehicle, much easier to access

[emmaalmanza]

Thanks for the walkthrough, and your are correct. This RC is not for beginner/novice but it did light up my 11 year olds eyes. She asked if it could go faster?

[RCRoads]

Awesome rig. I really like the cage. It looks beefy.

[Sandman]

Tapped a hole in the top lid of the case over the bind button. Put short servo lead extensions on all the channels and ran them out of the box. Can bind update or replace servos or anything and don't have to take all of them screws out anymore.

[nicklorenz]

Your the man! Thanks so much bro I was so lost

[jasonbell]

I give up on the Spektrum setup, I'm going with something different on my Ryft!! Great video though!!

[redvikinghobbies]

9 screws. You can leave that brace on. Thank you to JJ's HOBBY POWER!

[jjshobbypower]

Nice explanation there. You actually only need to unscrew the 2 screws on battery tray then the 3 screws on the underside and the receiver box will come off. Next is another 4 screws on the receiver box cover and that's it, in total 9 screws. I have binded the Ryft with my DX5 Rugged and so far it is still binded. I wonder if it is the compatibility of the receiver and DX3 transmitter. 🤔👍🏼

[misokovalcik]

Hello what shocks you use? Thank you for answer

[sclarke]

Your refrigerator is doing that because there is a magnet in between the doors that let the board know that the door is closed it has lost polarity or slipped out of position
Try and use an external magnet and slide it on the inside edge of the door (try both) to see if the light goes out

[ScottMcLinden]

Still thinking about getting one of these.

[ernestcoker]

There's a easier way that's the hard way