Top Phase Converter Tips

In this video, Chris shares the Top 5 things you should consider before your purchase such as:

-What you need to run a phase converter.
-How to determine the right size phase converter for your load.
-The right phase converter for your type of application.

For more information contact American Rotary at 888-743-6832.

[ultramaxracing]

I have their product. the best in the industry. I had a phoenix phase converter. it was a piece of junk. American rotary helped me out with great customer support. I run their unit 10 hrs a day 7 days a week

[jasperjones]

How do you mount these bottom isolation pads the bolts go right though what holds it onto the motor?

[sixtovargas]

I have a granite bridge saw and is a 3phase I want to know what comverte should I used for that machine?

[hamzadorukyldrm]

Hi there
I've bought a pizza oven lincat po360-2 it's 14.4kw 400v 3phase what size of converter I need to buy!???

[martinmoffitt]

are they ever bolted to the ground or just sit there??

[perceive]

so how are you balancing the run voltages coming out of the converter so that they are say + - 10 % of each other? Are you using a microprocessor to do the switching with run caps or just run caps alone?

[behrooz]

I have a good question, It the out put a 3 phase of 120 degree or 90 degree? In other words is that covers the hole cycle or just covers 270 degrees out of 360?

[jb-iksj]

i have a 15 hp motor used to drive a hydraulic pump. i suppose a 5 hp would work, but i just happen to have a 15 hp laying around. the rpm is 1750 the amps for low voltage is 39.3. what would u recommend? thanks

[Steve_Just_Steve]

In regards to #4- Why don't you use a TEFC motor standard? This is a genuine question as I think theres an answer just not sure of it. Thanks

[deej]

That was a great video. I need to add one of these for a 3HP Pulverizer. The Amperage is 10, so I did the calculations and it looks like a 20 amp circuit will run this. The motor is a multitap voltage, we are going with 220. We Have a 20 amp double pole breaker with #12 wire going out to the box where we want to install this. Any suggestions on products? I need to go to your website and look at options. It will be located outside, but well under cover from moisture on a loading dock.

[illuminationtrick]

Why it must be multiply to 1.6?
Why 1.6?

[paultanner]

I’m new to your channel and very interested. Just subscribed.

[tristanpatterson]

Do these converters work on multiple earth neutral (M. E. N) electrical systems?

[AdamOutlaw]

Was looking to run a 5hp 3 phase air compressor but these things are $2700.00 vs just buying a single phase motor for $570.00 a Baldor. These converters are not worth it they cost way to much you might as well have 3 phase ran from the pole it would be cheaper then these things