3D Printed Dream Storage 😍

I made the perfect spot for my iFixIt kit on my hexagon storage wall. I'm in love

[bananasunday]

50% infill 500% supports, it balances out

[anklemonitor]

Glad I'm not the only one pained by the support material.

[derallgaeuer]

All that supports going to waste. A simple design change and you will need no supports

[LandonKraftz]

Amazing print but why so supports? Just curious if I should do the same if I make it [:

[oleholeh]

I was also wondering of the supports part.

Add dovetail joint on a side and you saved a ton of support material.

[toastermon]

Very nice design but as others said, a lot of support Material couldve been saved by some slight design changes (adding screws would probably even increase part longevity)

[lokithegodkiller]

I know those tree looking things are just structure supports, but you should totally make like a giant board to put them all on to make a 3d printed forest.

[nannesoar]

I've never printed a single thing and the wastefulness of that first design blew me away😔

[davelordy]

Weird orientation on the first print we see (the one you remove supports from), why not print it flat ?

[mourning_sage]

So i know a lot of folk are roasting on the supports themselves, but im here to ask you about your support interfaces because that came off clean as heck!

[WatchesTrainsAndRockets]

Print it standing on edge at a 45 degree angle and a single triangular wedge to support i and you need no other supports. Check out som of Slant 3D's videos about how to design and print with no generated supports. I have used several of the techniques and it really works and saves a lot of waste and cuts down on print time.

[mr-dolphin-dude]

If you don’t mind me asking why did you design the tray to fit into the smaller hexagon inserts instead of the big hexagons the board is made up with?

[mcmach]

Do i need to unscrew my lens? Is it something i should be doing? Am i missing out??

[rinyotsu.]

I actually got nauseous at that support forest. Please tell me you're at least repurposing them!

[BennettsAmazingWorld]

I NEED HELP SOMEONE PLEASE RESPOND 🙏!!! I'm having some issues with my ender 3 v2 and I need some help. When I preheat the bed and nozzle it starts to beep after like 30sec, the bed heats up fine and shows the temp. The hotend on the other hand just stays around 20c. I have replaced the motherboard, heating element, thermistor, hotend, the hotend fans, and checked all wire connections, oh ya and i also updated the firmware! It's still beeping 😭😭😭. I have looked in and out of youtube and google and it all says bad thermistor, falty connections, or bad heating element. But iv replaced those!!! Someone please help if not I might just throw it out.😢

[therese_paula]

There has got to be a system for recycling all the poops and support that is accessible to all

[upshiftgo]

When your support is more significant than the product. 😂

[militarypaintball]

So much supports, please go into the corner of shame !

[jsavage]

Could you design something similar for makeup brushes?

[yrlix]

Where could I find the files for this? i love the hexagon back plate