Tuning Holley for Rotary engine

There aren't many videos of rotorheads tuning a Holley for the purpose of using it on a rotary engine. They Holley is a great carburetor for the rotary, and with some patience and understanding of the needs of the rotary engine, you can gain some horsepower by taking some time and learning what things to change and how it effects the idle and overall performance of the engine.

This car is a close friends car, full bridgeport 12a, has 2 MSD boxes, 10mm magnecor wires, and Holley fuel pump red.
The fuel jets are 68 on primary and 67 for secondary and it has a power valve block off.
The car had a pretty difficult rich spot on wide open throttle that caused a stumble. It needed more air, so we increased the air bleeds all around.
For the primary side we changed them to .69 on the idle air bleed and .55 for the high speed bleed, and on the secondary we went with .46 on the idle air bleed and .70 for the high speed bleed.
This resulted in a great idle, and great response without any hesitation at the wide open throttle.

[jengon]

Thanks I would love to see more videos on tuning and special timing with bridge port video was great haven’t seen a holley work that good in a while

[edwincasanova]

Nice a i love rotary i have rotarys down here in the island puerto rico

[JuanDa-zzvx]

I ordered a 600CFM Street Warrior For my 13B

[DraykoV]

what are the parts needed to installed a Holley brawler 650 I have the carburetor itself and the racing beat intake manifold

[theccwdad]

How do you monitor af ratio on these cars for tuning? Wide band?

[houstnstrng]

I have a 13b with carburetor but I’m not getting much gas in the carburetor any idea what it could be idk if the carburetor needs tuning or something

[WeekendsInJapan]

Heck I have a question, I picked up an rx8 with a bunch of issues I’m thinking about getting like a s4 13b bridgeport and putting a carb on it? Would you recommend a holley carb?

[kcpsjtc]

Is there any way i can get in contact with you? I also have the same setup im looking for some tips

[SvoBrianRobles]

Can I run a Holley 600 on a stock 12a with 54 Jets or what do you recommend?!

[chris-tcpx]

Hi do you have the msd boxes set up in 6 cylinder?

[jengon]

What carb do you recommend for 12a full bridge port

[RotaryA]

Tie those omp lines up with a zip line . Don't want to run the rotor dry