Change Proteus Trace Size and Layer for Auto Router

Choosing Layers and trace size for specific nets is a critical feature in any PCB design. Proteus allows you to assign trace size and rules to individual nets or classes within your design. This will work for both the auto-router as well as the automatic trace selection. In this video, I also show how we can choose a specific layer for a net class and a handful of other tips and tricks. I hope you enjoy and I look forward to hearing your feedback and questions.
Thank you!

#Electronics
#Proteus
#PCB
#MakerSpace
#ScottCard

Checkout my webstore:
proteus trace style
Proteus Trace Size
proteus layer
Proteus change trace style
Scott card
Single layer autorouting
proteus auto routing
autorouter
trace layer
auto routing in single layer proteus
Change trace size
pcb design
electronics basics
pcb layout
pcb cad software
proteus 8
pcb designing
advanced Proeus Design
advanced pcb layout
trace on one side
proteus limited to one side
pcb design software

[cr]

A setting up design rules video would be very interesting. In particular I'm wondering how to prevent Proteus from auto routing power and ground traces when I already have a power and ground ground plane...

[federicosvanascini]

Great Video. Thanks for your time. hug from Argentina. Have a good day.

[juannadie]

Excelent tutorial, I wonder if could be possible to create in Proteus a trace with 2 different widths. I have seen this kind of trace in Altrium PCB layout. It was used in Arduino Pro Mini PCB design in the zone the trace has to pass between 2 pads of the Atmega328p tqfp32 corners (there the trace is width decreased to prevent too close distance when pass between 2 corner 45° pads). I could not find the way in Proteus and I personally prefer it (much more intuitive and friendly) to Altrium

[adeshinaajibola]

Admin.Pls kindly make a tutorial on making gold finger pcb in proteus

[jlungumax]

Hi
Please make a video on how to select through hole parts

[eliesawma]

How can i add a battery on the bottom side of the board?

[adeshinaajibola]

Pls upload making high voltage pcb in proteus

[mahfoudiarabah]

Please what is the standard thikness and can we change it ?

[samobenedicic]

Since I don't know how to ask a generic question (outside of the specific topic of this video) I'll do it here. I had a project involving switching 230V AC on a board via SSR, load about 300-500W, depending on which parts on the output side were active at the time. I ordered the boards from Chinese manufacturer and copper there is pretty thin. I've never managed to route the same connection both on top and bottom copper (same route on both). Is it even doable? To have the same track on top and bottom copper?
Regards,
Samo

[adeshinaajibola]

Good day Admin. Pls how can I print clone or trace circuit diagram design make new pcb circuit print in proteus

[jlungumax]

Hi
Please make a video on how to select through hole parts