Cisco Catalyst 9800 WLC WLAN Setup

In this video, I will show you how to configure a new WLAN SSID on the Cisco Catalyst 9800 Wireless Lan Controller (WLC).

[ashokreddyb]

I can't thank you enough. I was literally struggling for this video. Finally found this. Gratitude 🙏.

[khiz]

Thanks for these videos mate. Quick question
dont we need to provide option 43 for APs to get the controller IP address ?
Also which Access point you are using

[taukirsyed]

Thanks for this video.
Clear
Concise
To the point
Nice music

[ziggypuppyproductions]

My router is OPNSense. I have a TPLink switch between the Router and the 9800-CL. I can get the plan set up and clients to connect but cannot get them to have IPs assigned by OPNSense. Where might I be going wrong? Thanks!

[MohammadRahman-hfns]

Please share cisco 9800- controller Flex mode configuration video and how to adjust RF parameters values in both2.4GHz and 5 GHz.. Good video 👌

[rajeshkundale]

Can anyone please tell me what image is used in the place of "Link to physical AP"?

[ptlgmtx]

what is the default username and password on the C9800 on lab sir?

[mikhailkevin]

how to make AP associated with WLC sir?

[technicaltips]

Why you didn't assign ip address to vlan

[eliotness]

Hi,
thank you so much.
as far as I understod Interface eth0/0 where AP connected is a trunk or access with vlan 10 ? it should be access?

Interface eth0/1 where WLC connected is a trunk definitly, with allowed VLANs 10 and 20

[Gamming-clgq]

could know how to add AP cisco on EVE ?

[athiel]

Your support is 100 hundred times better than Cisco!

[Abdlsam]

HI,

This was the best video i have seen for WLAN,
I have small issue with my Controller when i am using console I am able to go into into enable mode and configure mode
but when i am trying SSH i am getting this error
%Error in Authentication

Can you please let me know what i can do to work in SSH

[alexsanderjordanov]

Hey, can you share the best practice config for 5Ghz and 2.4 Ghz, please?
I can assume that this is the "Typical" RF config you mentioned.

[abdus]

You didn’t show how to enable https management


Or how to configure the management vlan on first run!

[blsmrz]

after the setup my radios go to up state for a sec then go back to down, any suggestion?

[tshoss-ngoma]

I like your tutorial, thanks! Can you show how you configured your external switch (Link to Physical AP)?

[Lee-qpet]

All to this day, I'm still waiting for someone to setup the WLC without using the wireless setup Wizard

[JLTA]

Can you make a web authentication video please

[vikramshekhawat]

Vedio is really good but this background music is so annoying