Pinning Demonstration: 2014+ Chevy Silverado & GMC Sierra Ignition Lock

In episode 7 Jeff Baker goes through the step by step process of pinning the 2014+ Chevy Silverado & GMC Sierra 10 cut ignition lock.

For more aftermarket solutions visit us at

[jacobgoodwin]

Very helpful! Had an issue with a 2016 GMC Sierra, I was taking the ignition tumbler out to replace the ignition switch and didn’t realize the front most shaft got stuck in there. Used your video to figure out how to put the locking tabs in with the spring. Thank you for detailed video!!

[alberts]

Thank you so much. Very very clear instructions.

[renedelrio]

Great video as I am in the process of replacing one, and I got stuck with missing the step with the retainer. Hopefully I can try this again tomorrow and get this vehicle on the road again.

[Middle_American]

Thank you for this video. I was able to use this video for guidance to change the cylinder on a 2014 Silverado.

[CarlosFlores-zvpv]

Tnx for your time and knowledge very well explained video and audio are perfect tnx

[thegonz]

Strattec 7024124 GM Ignition Lock..2016 sierra bought new, 135k, pulled into rest stop, got back in, key would not start to go in.F'd with it, finally took oil from dipstick onto key, got it to go in, giggled until it turned.Giggling would get it to turn ordered part next day.No warning fail.How about you, quick fail? miles?

[DIYeverything]

Awesome video very very clear and helpful.

[thegonz]

This vid helped 100% i did have to tap the collar sleeve on.with nothing in the cly it would not slide on.All seems good but dont like the force needed compared to this dude sliding it on. Strattec 7024124 GM Ignition Lock

[felixcordova]

Is there a video about how to disassemble the ignition after coding

[lockeyestlocksmith]

Nicely done Strat Teck, keep up the good work

[benjasvargas]

Thank you So much for the video you the best

[bradhartsoe]

How do you remove the cylinder from the ignition Lock Housing if the key will not turn?

[tinhtran]

I try for my truck but can not put in?please help me

[cw]

Now make a video on how to put the cylinder into the ignition housing

[felixcordova]

Is there a video on how to disassemble after coding ?