Hardwood Floor Installation Nail Down

Hardwood floor installation unfinished
Install Solid Hardwood Flooring white oak

We installed this white oak unfinished hardwood floor The wood is a 3/4 inch thick and 3 1/4 inches wide.

Hardwood Floor Refinishing New Jersey Installation, Repair, sanding

Connect with us !

[Crazyman]

Hardwood floor should have a random pattern. The stair stagger is very boring and artificial looking. There is no need to pound it out this fast, all you end up with is sloppy finished carpentry. Those base boards should have been removed and the hardwood not closer 1/4" to the wall to allow for expansion and contraction. In a few years this hardwood floor will buckle and pop.

[joshuamontgomery]

I mean, yes this is how a hardwood nailer/stapler works .
But this pattern looks terrible, and the baseboards 😮sheesh

[bryce]

Hardwood I did today had so many defects and split boards, bad finish and dents so easy, plus humps in th3 plywood really bad, then realize my new knee pads where denting the floor from my button where the strap hooks onto, they move to the side a bit and you put pressure and it dents into the

[saullgarcia]

Si le puedes poner toda la caja de grapas a esa sola tablA quedaría mejor amarrada

[efthimios]

I installed many hardwood floors as as amateur and never used so many nails once you see the piece sucked in your good 👍. Struggling to device hardwood va lVP

[grand]

You’re building stairs bro. Is it your first big day? 😂😅

[lumberjackhardwoodsupply]

This guy knows what he is doing. Bunch of haters in these comments.

[Frank-rsrq]

Installing for your house, should use another or better patterns, no staits... or more than 15 cm distance.

[anthonyb]

You never want your boards to be lined up like this

[maxlosch]

Solid floor. Good nail spacing. Shit pattern. Joints are too close. Should start with a step of 4 ish rows and get random w it. Steps don't hurt when they are at random, not like this.

[LUVVBANDS]

What’s the black material under and how do I remove it?

[sergioluisromero]

Te falta man siempre hay que dejar despegado del base borer

[Von_]

Joint seams are too close in my opinion . Wood flooring should be random. Also i would have cut under the baseboard and casing so floor could slide under just enough to hide it while still leaving room for expansion. Quarter round or shoe moulding is not very attractive.

[Gregj]

You can tell that the people commenting here either A don’t know wtf they’re talking about or B couldn’t even figure out which side of the board goes up which is why they are watching these videos to begin with. Then people commenting on the baseboards? You can barely see the baseboards and he’s not demonstrating baseboard installation. Wtf does that have to do with anything? I’ve been a wood flooring contractor for 36 years and if I wanted to be an anal retentive asshole I could maybe say he could open up the head joint spacing slightly but that’s now even an issue here. Grow up people. I’d love to see the haters do a wood floor installation demonstration. They’d have to put it in the comedy category because that’s what it would be. Nice job pal, haters gonna hate.

[shantor]

Another stair stepper. Horrible like speed nailing roofers

[txvgufk]

So much for the expansion gap… crap installation

[thomasgarcia]

we use starter boards and go random as hell. to many stair steps.