Artillery Sidewinder x4 Pro - Fast 3D Printer with Linear Rails

✎STL FILES:
Fox:
Dog:
Helicopter:
Tolerance coin:
Test cube:
Vase:
Flexi cat:
3DBenchy:
––––––––––––––––––––––––––––––
✎MUSIC:
Infraction - I'm good (Positive rock)
––––––––––––––––––––––––––––––
✎3D PRINTER: Artillery Sidewinder X4 Pro
––––––––––––––––––––––––––––––
✎INSTAGRAM: @3dprintsbuilds
✎TikTok: @3dprintsbuilds
#3dPrinting #Timelapse

[Perkeletricksterservantofrher]

5 : 42 You saved my printer print bed so you earn a sub. Thanks bro appreciate your warning and guidance. Do you think it's mandatory to grease the rails or do they come pre greased ? I forgot too and had a 24hr print on.. will it damage ?

[mikeskerritt]

HI it looks like bit of a deaster. Have Artelpry cured these problems yet wint a fewer freeware release.

[artmanstudios]

Well it doesn't seem like at least much to desire seems like it has a lot of Error problems!

[arda-shqx]

Hello. You were the first channel I watched that neutrally listed the disadvantages of a product. Although the Artillery Sidewinder x4 Pro may seem like a good printer on paper, the disadvantages you mentioned in the video cannot be overlooked. I'm planning to buy a new printer these days. There are two printers I'm torn between: the Artillery Sidewinder x4 Pro and the BambuLab A1 Solo. Buying the Bambu printer might financially strain me. Which printer do you think I should choose? Would it be right for me to put myself in financial difficulty by purchasing the BambuLab printer? Is the Artillery Sidewinder x4 Pro sufficient for hobby use?

Also, I'm open to other printer recommendations you may have. Regards.

[redrocker]

Hi, I've got this printer over a week ago. First prints were very nice, but the more I printed the more quality dropped. As this is my first 3d printer I didn't really know what was wrong and why it failed so much. It turned out that I have to level it again, so I started doing it, but It's fcking impossible. It's absurd how difficult it is to level this printer. Can you give me some tips how to level it? I've found out that no matter what z-offset I'll set with a new firmware (from 19th march), once I tighten the knobs bringing the bed up to the nozzle, the printer ignores the z-offset I've set, because with every new print it goes to home position, checks for bed height with a nozzle and ignores the z-offset I've set to not let me scratch the bed. No matter how high I'll place the bed with knobs and how low I'll set the z-offset, even under the bed, the printer just ignores it. What do I do?