How To Configure OSPF in GNS3 - OSPF Routing Configuration Step by Step - OSPF Basic Concepts

How To Configure OPSF in GNS3 | Open Shortest Path First protocol.OSPF Concepts. Hi this mohd salman's tutorial video about ospf routing protocol..cisco ospf protocol.
The OSPF (Open Shortest Path First) protocol is one of a family of IP Routing protocols, and is an Interior Gateway Protocol (IGP) for the Internet, used to distribute IP routing information throughout a single Autonomous System (AS) in an IP network.
An introduction to Open Shortest Path First(OSPF). This video explains OSPF features, OSPF hierarchy, configuring OSPF, verifying OSPF and gives OSPF details.
best CCNA Course on the Web.OSPF is perhaps the most widely used IGP in large enterprise networks
To enable OSPF on a Cisco router and advertise interfaces, the following tasks are required:
Step 1- Use the command router ospf process ID to start OSPF.
Step 2 -Use the network command to enable the interfaces.
Step 3 -Identify area assignments.
Step 4 -(Optional) Assign the router ID.
OSPF has no hop count limitations. RIP has 15 hops only.

OSPF understands variable-length subnet masks (VLSMs) and allows for summarization.
OSPF uses multicasts (not broadcasts) to send updates.
OSPF converges much faster than RIP, because OSPF propagates changes immediately.
OSPF allows for load balancing with up to six equal-cost paths.
OSPF has authentication available. (RIPv2 does also, but RIPv1 does not.)
OSPF allows for tagging of external routes injected by other autonomous systems.
OSPF configuration, monitoring, and troubleshooting have a far greater IOS tool base than RIP.

[thejmcexperience]

Excellent video (except for the music). Just following along has made OSPF crystal clear to me. I can reproduce the steps shown in my own GNS3 setup, and really get to know OSPF. Thank you for this very useful video.

[e.aldeen.a]

so good>>thank you so much>>please do not stop

[AliOsmanHocam]

Perfect video just as I wanted it.👌 A very useful sharing.👍 Thanks to you, I understood both using gns3 and opsf. Thank you so much.
🙏

There are EIRGP videos among your videos, I will definitely watch it. Do you have a document with schemes and configurations of dynamic routing protocols? 😊

[LucasSouza-phug]

what console is that like it before putty one...

[ddcd]

Hello, is it needed to configure OSPF for 192.168.1.0 and 172.16.1.0? I don't think so since on that interface there is no router but rather a switch, so all it's needed is to configure the interface. What do you think? Thanks 😊

[amangoyal]

Hi I am new to GNS3, could you please tell me how to get these devices that you showed in the vedio. My Gns3 does not show these. I would really appreciate of you can give me a some links to download and how to use them.

[charisrevo]

Thank you sir great video. I wonder what is the main reason you put 0.0.0.3 in wildcard mask instead 0.0.0.255?? I still new in this field, please kindly answer if u know

[dvij]

If there was explanation instead of music on background on what you are doing and how you are performing this OSPF configuration, it would be highly appreciated. As not all of the viewers knowledgeable for this setup.

[amrita]

Good video, but you could have explained the process instead of playing music in the background.