OSPF Routing Protocol using Cisco Packet Tracer

This video explains step by step procedure of how to Configure Open shortest path First(OSPF) routing protocol which is internal (Intra-domain) routing protocol using cisco packet tracer

[esportsgaming]

I'm very happy by seeing your vedios of Cisco packet tracer mam because ours lecturers wont explain good like u that u explain . Thanku mam for good preparation for exams

[DileepKumarMB]

Nice explanation... Good introduction to ospf using "Cisco packet tracer".

[mohdyusufkhan]

Very well explained. Finally understood ospf

[claudiusdsouza]

Thank you for the video. the explanation was very crisp. Could there be more explanation on commands as beginners find it difficult to understand the purpose of the command

[ssmarcosvinicius]

thanks!! you saved my life and dignity!!! Love u <3

[mdmahfuz]

Thank you so much for beautiful exaplannation, it was very helpfull.😃😃😃

[sreeharivs]

Great explanation for the practicals . Just a doubt does ospf really care about the number of routers or the cumulative interface cost

[fizaansari]

Thank you so much...You made it very easy.

[manuelmilla]

bravo! very good explanation about how to set up a network inside an autonomous system

[ferenccziryek]

hi thank you, should I give static route? ping itt does not reach from pca to pcb only def. gateway.

[educationsingh]

Their are, 3 modes in CLI and all this commands doing in 3rd mode, for doing first enter en( enable ) it set u in 2 nd mode after config ( configuration) u enter in 3 rd mode . This ospf protocol command done in 3rd mode of router . Thanks u

[lucky-gvfh]

Madam in CLI while we are doing with the commands is there any sequence of the routers

[saadabdillahiali]

nice explanation but I could not send from ROUTER2 to PC1 could you explain me plese ?

[manuelmilla]

in router configuration in packet tracer 6.2 I have an error in CLI. It can be solved typing
enable
configure terminal

[jannatulferdos]

Is it mandatory to implement OSPF in CLI? Is there no interface?

[DheerajKumar-ogmf]

Hello MAM you told in ospf brief, OSPF work in autonomous system but ospf doesn't work autonomous system, It use process id and area only.

[notasongapart]

You could have used RIP instead of CLI, that would have been easier.
But Thanks for you efforts, you helped us a lot

[minakshibalaram]

Please clarify the use of Product Id number and area number and when it change?