BEST WAY TO FIND YOUR ANGLE WHEN INSTALLING SIDING!

[pjlupo]

Thanks you for posting this - I was not understanding other videos showing how to find angle with a speed square or other devices. This is very fast and simple, thanks for sharing your knowledge in a clear and concise way.

[ramblinon]

You did an awesome job simplifying this. Thanks!

[Storm-fmhv]

I'm doing a garage rn and I was correct with the way you were measuring but when you said the bottom was your offset it opened my eyes thank you

[byteme]

Gosh this is so simple it hurts. Was struggling with angles and math doing a shiplap project along and angled ceiling and this will work perfectly while saving so much time! (And probably be more accurate😂)

[XroorX]

Doing a siding job on a 1955 house I am selling….what keeps the wind from blowing out that sharp corner in the angled j-channel? I had a 16” section of siding blow out on a similar location/angled j channel. Thanks

[highwatercircutrider]

Your making your angle cuts way harder than need be. Just use a shot piece, tuck it up in the j channel or up to the drip edge over another piece lock in place and slid over under then mark off the top piece, easy ! Siding contractor here since 1972.

[midnightaria]

Installing siding with my husband this weekend. You just saved my marriage lol

[carguy]

I knew there had to be an easier way. Thank you!!!

[jobiscoe]

I have wood siding but this was soooo helpful!!!

[pendiesel]

Definitely needed this video… Appreciate it 💪

[stickjr.]

Your the man!. Thank you!. When you took that measurement from left to right. Did you run the tape measure uptight to the j or did you leave a little gap to find that 30 inch measurements.

[stevenfoust]

That’s one of several simple ways to do it. Most guys will take a piece set to the roof angle and mark it off on a short piece so you can make a pattern for cutting several pieces saves a lot of time cutting a few at a time

[erikcaldwell]

How can i get high(like 40 foot) and do this without scaffolding?

[Brandon-novc]

@39 seconds dont you want a 1/4 inch space in there for expansion?

[pa.fishpreacher]

I thought you said 3 inch overlap, If that is vinyl why 3 inch over lap ??

[tobbyscott]

i tired this method did the same way and its off everytime >:( not sure whats wrong

[stonedrew]

Why not measure up 9. 1/4 from where it snaps in to the jay channel the mark where that is down to where the angles ends

[hhprogressiveconstruction]

Yep Hang siding not nail it 👍 . Over nailing that flange without spacing really makes the panel useless .

[armands]

Takes 2 pieces of siding and no tape at all for the angle. Your angle becomes a template.

[armands]

Your method was my old way, which is good. But if I could show you how to cut your time down by 50% it's better.