MT12 Cutting Slots and Keyseats

Explore how to cut slots and keyseats on a Bridgeport Milling Machine.

[derickgillispie]

Great video for beginners like my self!

[duanedean]

Use a micrometer to measure stock diameter, then use micrometer to measure depth of keyseat. Subtract the two and you have depth of key seat. A depth mic will give you a wrong reading because you removed the crown of stock, so your measuring below the point of where you should be, and that number is allusive and hard to get.

[subodhsoni]

Measuring method of key way depth is wrong here. It will not give correct depth reading at the place where it is being measured because height reduction is there at key way edges.

[gowthamramesh]

how to make opposite key way in shaft
Upload this video much needed

[karlulvestad]

And i just wondered about Morse taper number 12 lol- how fucken big would that be🤭

[KristhianCortes]

Hi, great video! what is the name of that reference book? thanks in advance

[galloaguilar]

Yo trabajo en eso pero a escala grande en pies asta 25 feet