How to use Mag Drill & Annular Cutter like a Pro? | How To Use A Magnetic Drill? | Made in Germany

Select the correct annular cutter for the material to be drilled.

Select the correct ejector pin for the cutter length.

#howtousemagneticdrill #howtousemagneticdrillingmachine #howtousemagdrill #howtouseannularcutters #howtousecoredrills #howtousemagneticbasedrillingmachine #howtouse #howtousedrills #howtousedrillpress #howtouseportabledrillmachine
Insert the ejector pin inside the annular cutter. Never use an annular cutter without an ejector pin.

Insert the annular cutter in the machine KEYLESS arbor.

Move the machine towards the mark where the hole is to be drilled and with the help of the pilot pin locate the mark by touching the tip of the pilot pin over the mark.

switch on the magnet switch. Check if the magnet indicator glows GREEN.

Fill the coolant tank with BDS lubricant. Never use the machine without lubricant.

Set the correct RPM on the machine for the size of the cutter being used.

Turn ON the coolant tank knob.

Switch ON the motor switch and start to drill with slow feed. Never crash the cutter on to the material.

You must use the internal lubrication when drilling with annular cutters. Also, use external lubrication when drilling above 50 mm thickness.

Start to drill with a firm steady feed rate. Too slow or too fast feed rate will damage the cutter.

Check if the lubricant is coming out. Use a lot of lubricant for good results.

Putting too much pressure on the feed handle will not make drilling faster; instead, it will break the cutters.

Drill with less pressure and steady feed for best results and longer service life of annular cutters

To prevent long chips forming you should use reverse feed when cutting deep holes.

To prevent accidents clean the work area with BDS Power cleaner after drilling.

Perfect drilling with the above instructions will result in perfectly finished holes, in less time and with more service life of both cutter and machine.

Simply better drilling!

BDS Maschinen GmbH (Germany)

[gibbygibstone]

Great product guys. Truely a thumbs up. Please do your customers a favor; in the future and remove the banner going across the area of interest and hiding the reason we're watching the video. That'd be even better. 5 of 5 stars though.

[PatrickWagz]

"Use lots of lubricant for best results!!!"


;-)

[josecarloscarrasco]

I have a question. I would like to know if you have a manual or some kind of help to connect the electrical circuits inside.

[msdweldingfabrication]

So once you start the cutting you're not supposed to ease off on the pressure on till you get all the way through?
I think I've been doing this wrong

[nealk]

What type of cutter is used for ar 400?