Woah! Don’t OVERDRY your filament! Tool Tip Tuesday!

Woah! Don’t OVERDRY your filament! Tool Tip Tuesday!

This post may contain affiliate links. From time to time, I recommend products or services I have used or know well, and, as a result, I may receive a commission if you purchase them using the affiliate link. Purchasing from affiliate links is at no extra cost to you.

#3dprinting #3dprint #filament #tooltip #shorts

[Maennlein]

All I hear is the tune of Mark Robers Videos

[KasketsD]

In art, all mistakes are opportunities for unique variation and individual technique. Just keep it in mind and use it on purpose in future projects or else it really will just be relocated to a mistake that happened in the past.

[renownedbandanawearer]

That transparent/translucent filament in the cutaway caught my eye right away. Have we seen any prints of that yet? 👀

[FPV_KEVLAR]

Great advice Just subbed to the channel Just getting in the 3D printing.

[dinosoarskill]

there’s so much improvements for the world of 3d printing.

[jhowd]

The humidity level on my AMS says 10% with all 4 rolls in it, is that too dry?

[mrjibrhanjamalkhan]

I really don't know why but I really like her

[terkq]

Do you mean that we cannot dry it without printing smtg?

[angel-angel-angel-angel-angel]

I cooked my pla in my dryer😂 it was set to PA instead of PLA, 70°c 😂😢 for about 40 minutes ish it only melted a little but the spool I printed got deformed and it fell and left an imprint in the pla, the dryer is the sunlu s4

[surronzak]

Those aren't dryer as the humidity can't escape, they are just heater, why has no one build a solidstate membrane dehumidifyer, as this really takes humidity away and is cheap, I really hate bad information and understanding of simple physics, missleading millions off people into thinking they bought a dryer instead of a heater. Put a VPD metter inside those "dryer" and see how the value wont change as the relation between temperature and humidity remain the same

[alexvanderkleij]

Overdrying? No, you just overheated it locally.

[Ambionics]

If half is a different color, it's only half dry