RFPro-24: Simplifying Multilayer EM Simulations with RFPro

Watch this video to understand how can you simplify your multilayer EM simulations with great ease in RFPro without having to modify stackup or layout in any manner.

#rfpro #emsimulation #ads2023 #multilayer #rfboard

[HugePlays]

Hello, if you have an existing PWB design that has a lot of ground vias for stitching layers together, is there a way to automatically reduce the amount of vias used during an EM simulation or does one have to manually delete the vias in the layout that they do not want to simulate in order to speed up simulation. Is there an easy way to simplify the ground vias for an EM and reduce simulation time/resources automatically or does one just have to manually delete extra vias. Thanks for all the video, 10/10 and shared with many!

[rewaamaher]

Thank you for your helping videos
Can you please make a video about how to use SDD2P in ADS by an example?

[李云-or]

Teacher, I would like to ask ads if there is any way to model parameterized like hfss. For example, (x1，y1) and (x2，y2) to determine a rectangle. The modeling method of ads is too complicated to adjust. Or can hfss call ads's simulation algorithm? hfss runs too slowly.

[abhijithas]

Sir please upload a video on LSSP and how to plot on rectifier.

[nusermane]

Thank you for all these great videos!!!
As a complete beginner with RF design tools I have a question:
I am designing a passive transponder, consisting of a substrate with a bottom cover-sheet and a top layer.
On the top layer there are two patch antennas, matched each to 50 ohms by an inset feeder, the feeders ends face each other, such that one antenna is oriented to the right, the other to the left hand side.
In between a diode has to be placed as a nonlinear element.
I don’t understand, how I determine the diodes characteristic impedance and how I do the matching, as well as the simulation in ADS.
Especially the placement of the ports for the simulation isn’t clear to me, since the transponder is not supposed to be connected to anything …
Do you have any ideas for me?
Thank you for your time, best regards!!!

[brothers]

hello anurag..my question is related to PA, i have design 45watt PA from 4.5 to 5 GHz using cgh40045f cree devices(0 to 4 Ghz).i use it above its inherit frequency. In layout simulation it gives 11 db power gain but after fabication it gives 7 to 6 db small signal gain i change the design with differeant tapology but result was same can you please tell me the possible reason..???