How To Make A Dado Routing Jig - WOOD magazine

preview_player
Показать описание
The problem, your project is too large or awkward to rout a dado joint on your tablesaw. The solution is using a router and a simple jig. WOOD magazine's Kevin Boyle shows you how to turn scrap wood into an invaluable jig to create both through and stop dadoes.



Рекомендации по теме
Комментарии
Автор

Devine timing, Exactly what I needed for 28 dados for drawers.

DanielGeorge-ct
Автор

Exactly what I needed for some garage cabinets I'm building. Thank you!!!

CROFTwins
Автор

Great video and very helpful advice. Thank you Kevin. I am building some bookshelves and after watching this just ordered a Freud 50-106 (my dados are larger than 3/4") and will build one of these jigs. I need to make 24 dados for the project and this will help a lot. No more measuring from my bit to the edge of my router plate. Again - many thanks. BTW: Good point on the snipe.

derekwhite
Автор

Groovy!
Something not elaborated but essential is the snugness of the edge guide blocks- they are also providing support to the edge grain to control tearout.

BiggMo
Автор

Thanks for a great jig and explanation Kevin. Like most table saws in New Zealand, mine has a short arbor so won't take a dado set. This is a great alternative.

rayanderson
Автор

Brilliant! 4 bits of good quality scrap, 8 screws and it's DONE!

I like the I-beam risers too.

lazygardens
Автор

I am a beginner and this is really helpful.

gallerycarnell
Автор

Very informative, no annoying music, thanks

tommcnally
Автор

Awesome. Is it just me but whenever I’m watching a woodworking video I always end up with the same thought; “I don’t have enough clamps…” Is it just me?? Haha

michaelbendixen
Автор

Thanks for the video man! Great content!

NSHomestead
Автор

Hi friends.. I am from Indonesia watching your video, that's very great ..helping me as beginner, good job guy 👍

mdarmawan
Автор

So much easier than the adjustable version. I don’t cut a lot of dadoes so this is perfect and I could reuse it if I don’t glue it

billbrammer
Автор

Good play.. old tricks for new builders.. well done! carry on!

tinkmarshino
Автор

Great one, straight forward.. Well done

mariojhorge
Автор

thankx alot i learned a lot from this video

omaromar-lgyu
Автор

I wanted a jig for my fixed router...I was so excited til you used a plunge router. So since I am not plunging, my bit has to go past the 3/4 inch plywood jig and then into the panel 3/8 inch. Is that possible without a plunge router? I just bought my router...so forgive me if this is a stupid question.

cherylspringtime
Автор

He say you could not teach a old a new trick. Thank you.

johnisley
Автор

How do you adjust the depth to 3/8 and account for the jig depth? Also did you intentionally make your spacers 3/4. Also how do you keep the router from cutting into the jig.?

BK-qulj
Автор

I like it. Follows the principle of KISS. (Keep it simple)

bobbiebittle
Автор

Do you have a quick sketch for those I-beams you are using to lift the panel off the workbench?

billbrammer