How to Program a Garage Door Opener Remote

How to program a universal garage door opener remote. Set up your garage door remote. This tutorial uses a garage door remote from Amazon but the steps will apply for any remote. Connect garage door remote.

-----------------------------------------------
Video Outline
0:00 Intro
0:25 Color of Learn Button
1:04 Program Remote
2:09 Connect Remote to Garage Door Opener
2:44 Test Remote
------------------------------------------------

Links to Purchase Products:

*Purchases made through some store links may provide compensation to Filip Tech*

[GIOATY]

Very cool little garage door’s remote control and very easy to program!

[debramoore]

This was so simple and helpful. I did it in a matter of a minute because of your instructions. THANK YOU!

[atticussandman]

This was by far the most easiest video of how to program the garage door opener . Five out of five stars. My remote wasn’t even the same type and it worked great.👍🏻 🎉❤

[ThingsoftheSort]

This worked for LiftMaster garage doors programming Chamberlain garage door openers. Thanks!

[HighMileageOffroad]

HELL YEAH BROTHER! Much appreciated! ❤

[pv]

Thank you for your video, expecially because you seem to be the only one i found who shows the chart, which came in very handy as I did not find anyone with a yellow button for the "learn" button so i didn't know how many times to press the button to program it! Your Video was very helpful.

[uoducks]

Doesn’t holding down the learn button usually clear any codes? Meaning it would un program a synced keypad on the outside?

[wingnut]

Does this unprogram other remotes or a visor remote?

[GarageDoorGuy]

you should get your garage door serviced. It appears to be unbalanced as there is a lot of slack in the chain. You can test the balance by pulling the red cord and then lifting the door manually. It should hold at 1/4 open, 1/2 open, 3/4 open and fully open. If the springs are too weak, the door will close back down. If the springs are too strong, the door will fly open and could damage your operator. If your door is unbalanced, call a trained technician because the springs are under massive amounts of pressure and could seriously injure you if you don’t know what you’re doing and just start messing with them. Hope this helps!!