The Qidi Tech Q1 Pro FDM Printer - Simple 3D Printing Beginner's Guide

The Qidi Tech Q1 Pro 3D FDM Printer can be purchased from :

For the X-Plus 3 head over to :

Support the channel and see the behind the scenes videos and blogs on my channel at
----------------------------------------------------------------------------------------
My Social Media, Merchandise and Amazon store can be found at :

#qidi #q1pro #xplus3

[MakeEveryThings]

I just buy the QIDI Q1 Pro but I have problem for print, I check the temperature on hotend with thermal camera and i see I have only 72 deg C maximum on hotend outside when I setup for PLA 220 deg C.
If you can please check with thermal camera what temperature on hotend you have on your Q1 Pro, thank you.

[billkaroly]

Do you have the older version without the ethernet port?

[robinaroundtown...]

Well even though I'm not doing any printing of my own...

You have presented this information like a true commercial spokesman...
Well done sir...well done 👍👍👍👍...lol
Best from across the pond mate...

[corinandrews]

Hi Wayne, amazing printer, did you print at 100% speed?

[hobonickel]

what no mention of the gazillion files that comes with it on the thumb drive? lol

[welshpiper]

Hi Wayne I'm in Birmingham ready 4 tomorrow's event MC, yesterday I messaged you about the Saturn 4 so with this FDM Printer one would be pretty much set up or woul you say the Saturn 4 would be enough this one look like you can get some high prints off it.cheers Mark.

[OS-RVfan]

Hi Wayne, thanks for your review. I'm wondering about the location of the filament feed through the housing in the top left rear corner (looking from the front).
In all the other reviews, the tube hangs out at the back, top right (looking from behind to the back of the printer)
I'm also wondering about the stop corners at the back left and right of the build plate. In the other reviews there is only one in the centre and was therefore a major point of criticism.
This meant that the build plate sheet could be positioned at an angle.

Have you received a new, revised/improved model from Qidi? May I ask when you received it?

If so, you should definitely point out that Qidi has made improvements 🙂

[gusbert]

If you are doing a printer review, please talk about the print quality, can you use any slicer or is it locked down to Qidi, what is the firmware (Klipper?), is the mainboard 32 bit, is it noisy?

[markoneill]

Hi Wayne, doe it auto level on each builds? If that's also impressive

[julianmhall]

Hi Wayne.. a quick question. I know you can put model files on USB sticks but can you also put firmware updates on them, or do firmware updates /have/ to be downloaded direct to the printer?

[Khoomn]

Why does the background music sound like I'm watching a horror film?