How to Replace Front Wheel Hub and Bearing Assembly 2009-2015 Honda Pilot

Buy Now!

This video shows you how to install a front wheel hub and bearing assembly on your 2009-2015 Honda Pilot. Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision.

This process should be similar on the following vehicles:
2009 Honda Pilot
2010 Honda Pilot
2011 Honda Pilot
2012 Honda Pilot
2013 Honda Pilot
2014 Honda Pilot
2015 Honda Pilot

Tools you will need:
• Socket Driver
• Anti-Seize Grease
• Brake Grease
• Brake Parts Cleaner
• Copper Anti-Seize
• Liquid Thread Locker
• Sandpaper
• Punch

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ Watch the Video
√ Do it Yourself
√ Save Money

[keithvick]

Excellent video. It's much easier than I expected. I'm going to purchase a new wheel hub for my wife's Pilot.

[Pilot]

Wish my 2005 Pilot had this set up. Great Job! Thanks! 😁👍👍

[bradjohnston]

Great video, I appreciated the torque specs detail.

[FranciscoPerez-ilrv]

Is the pilot 2016 any different than the 2015, i know the axle nut is 36 mm on my 2016, i need to replace wheel bearings

[RS-xoyw]

Seeing the new 35 mm axle nut socket not fit was real disappointing. Thought 3 trips would be enough but here I go again

[overpricedsundown]

Im now ready to tackle this job. If only my car wasnt a rust bucket

[iptvmonument]

What was the symptom of the wheel bearing? My 2010 Pilot shakes after pulling a trailer. I’ve changed tires, suspension, links, bushings. Running out of options. Thank you

[zaidgttam]

Mine took a 36mm socket for the axle nut.

[krispy]

I've seen anywhere from 181 ft lbs to 242 ft lbs for the axle nut. Might have to call the dealer to confirm or check the service repair manual if you can find one.

[mg]

I sure wish my Honda would use this style of hub and bearing on the smaller cars such as the Fit. The pressed in bearings are horrible to deal with.

[JUANR]

I just did this today and it was honestly the worst job I've done!!! Hammering that hub out was crazy!

[Noxious]

Why did you forget about the rotor screws???