Sharpening-Roughing Gouge #shorts

I am a Robust dealer (which adds nothing to your costs) and I am more than happy to help you pick out and configure your new lathe.

One of my first sponsors on PBS. They make excellent replaceable carbide cutter turning tools.

#woodturning #woodenbowls #woodlathe #roughinggouge #turning #woodworking #timyoder #easywoodtools #sharpeningroughinggouge #sharpening#robustlathes #woodturningwithtimyoder #timstools
#woodturningprojects #shorts

[hungrycolby]

This is probably the simplest most no nonsense explanation of how to sharpen a tool I've ever seen. Good on you sir!

[HappyHands.]

There's something very complete about using a rotary tool to sharpen tools that we use with our other rotary tools.

[robertrussell]

Nice job ! 30 years machinst here... ground all my tools by hand Not easy takes years of practice. Now we have C.N.C. once again good job.

[joelongstaff]

Sir thankyou for a great video. I am just setting up my first lathe and this is stuff I must learn. I am now a subscriber.

[pastorlarrypotts]

I really appreciate your excellent teaching on sharpening!

[pastorlarrypotts]

Could you please share where you purchased the Gauge with the different angles?

[randomusernumber]

i'd get a grinder that does the opposite way .Just to be sure that nothing binds up .

[chrisbraid]

Gee I just used to freehand mine, and it still cut Rough Well … preferred the bevel Chisel though … nice planing cuts and rolling cuts … ovoid section shaft was really nice too …

[LadZeroUltra]

You should balance the audio a bit so your voice is more audible over the music

[Particle_Accelerator_Repairman]

This guy sounds exactly like the Wrangler Star guy (pretty sure that's his name)

[aaronsmith]

You ruined the heat treat on that corner

[kludkux]

Where did you get that angle gauge, please?

[idontknowmyfirstname]

Got a bit of jig envy not going to lie

[lovetheNorml]

I've had that gauge for years. And had no idea what it was used for. Lol

[gavinc]

So you hit the inside of the curve with sandpaper or a file too?

[paulrawlinson]

Discoloured steel shows youve lost the temper at the end, and have a lot more grinding to go!

[wbplayers]

Solid lesson!

Probably be more legit, though, if you hadn't borked your cutting edge first. But otherwise: totally there! 👍

[desantiago]

What grit is that wheel and where do you get it? I just got a lathe and chisels.

[jameswynn]

What is the tool angle holder setup called? Sort of looks homemade

[_Egor_Egorov_]

If the sharpening angle is 44.5 degrees, will it not work?