Genie GS-1930 Operation Demonstration

This video will show you how to operate a Genie GS-1930 electric scissor lift.

[jbtwo]

Perfect video. Clear and concise. Have a good holidays and thank you for your time.

[Marsbars]

One of the best demonstration videos I’ve n YouTube to this day. Nice job man.

[bensonchukwu]

Nice information, passed my IPAF 1b, 3a and 3b

[Dwwantz]

Thanks very much. This was a great video. And much more helpful than Home Depot was in telling me how to use this machine.

[lordvalvatorez]

Thank you, you were clear and to the point. Much appreciated

[ismaelcazares]

Thanks for make it so simple and explain it so well

[Toasty_Britches]

This video was great! Taught me everything I needed to know.

[zacyoho]

Thank you... Saved me a lot of grief in asking how lol.

[conqwiztadore]

This video should be the first on the search results

[SwanOfficial]

There’s one of these at my high school. I’m gonna hijack it as my senior prank.

[arielmedrano]

At the job site with one. Now I know how to use it! Thanks Man 💯

[angiespencer]

How would you operate a fan while using one of these, gets pretty hot all the way up near the roof

[marvinjones]

At 1:48, you show us the auxiliary lowering cable. What is the other red handle, just to the left and below the aux lowering cable?

[naturewatcher]

I guess you can drive it on flat hard surfaces, not on a rough terrain. Plus I don't see any stabilizers to level it if the surface is not perfectly horizontal.

[BoomerXGaming]

Please update your video, I received my rental today and there is no switch from base to platform.

[questioneverything]

Does it work if you plan to start a rental business / side hustle with one of these machines? where can you rent it out?

[michaelnet]

Please I desconected the mangueras from motor direction can you share the diagram from motor hidráulico

[donmurdoch]

Great video. I am curious what the two push/pull knobs do at the back? (under the aux power cord) I am guessing Hydraulic related because of the block they go into 🤷‍♂

[JImRamos-yy]

Mine had bad brushes. Infinity resistance on motor. Brush worn very short, opened the circuit. Now I replaced the brushes, the motor runs but I cant get the lift to run the motor. I want to test the solid state controller that operates the motor. I have 24.5 volts at this controller and it should ground the motor to make it run. Two small terminals are 1 and 3. I dont want to apply voltage across them because I am afraid that wrong polarity could damage the controller. My display reads "READY GS 1930 385.5 Hours." Any suggestions?

[couchpotato]

Thanks for this video, it was very helpful. I know the lift has a continuous loud beeping sound when operating it for safety reasons but is there a way to lower the sound or temporarily turn it off/on.